Craftsman 944514360 Owner’s Manual

Instruction Manual

25cc / 1.5 cu.in. 2-Cycle

16 Inch Cutting Path / 0.080 In. Line

GASOLINE WEEDWACKER ®

Model No.

0944.514360

• Safety

• Assembly

• Operation

• Maintenance

• Parts List

/'/

For Occasional Use Only

WARNING:

530164826 3/12/04

Read and follow all Safety Rules and Operating Instructions before first use of this product.

Sears Canada, Inc., Toronto, Ontario M5B 2B8

Warranty Statement 2 Storage 11 Safety Rules 2 Troubleshooting Chart 12

Assembly 4 Operation 5

Maintenance 9 Parts List Center Section

Service & Adjustments 10 Parts and Ordering Back Cover

LIMITED TWO (2.)YEAR WARRANTY ON CRAFTSMAN ® GAS POWERED

WEEDWACKER ® LINE TRIMMER

For two (2) years from the date of purchase, Sears Canada, Inc,, willrepair or replace

free of charge at Sears option parts which are defective as a result of material or workmanship.

COMMERCIAL OR RENTAL USE:

Warranty on Gas Weedwacker will be 90 days from the date of purchase if used for commercial or rental purposes.This warranty does not cover:

1. Spark plugs, filter, line, spool, starter rope, and blade.

2. Damages to the motor of the unit when operated without the proper fuel mixture (see manual).

Warranty service is available by returning the Weedwacker to the nearest Sears Ser- vice Centre/Department in Canada. This warranty applies only while this product is in

use in Canada.

This warranty is in addition to any statutory warranty and does not exclude or limit

legal rights you may have but shall run concurrently with applicable provincial legislation. Furthermore, some provinces do NOT allow limitations on how long an

implied warranty will last, so the above limitations may not apply to you.

Sears Canada, Inc., Toronto, Ontario M5B 2B8

Emissions Statement 13

x'l _

llWARNING: When using gar-

dening appliances, basic safety pre- cautions must always be followed to

reduce the risk of fire and serious injury. Read and follow all instructions.

This power unit can be dangerous! Op-

erator is responsible for following

instructions and warnings on unit and in manual. Read entire instruction manual

before using unit! Be thoroughly familiar with the controls and the proper use of the unit. Restrict the use of this unit to

persons who have read, understand,

and will follow the instructions and warnings on the unit and in the manual.

Never allow children to operate this unit.

INSTRUCTION SAFETY INFORMATION MANUAL ON THE UNiT

DANGER: Never use blades or

flailing devices. This unit is designed for line trimmer use only. Use of any

other accessories or attachments will increase the risk of injury.

@©©

if_- WARNING: Trimmer line throws objects violently. You and others can be

blinded/injured. Wear eye and leg protection. Keep body paris clear of ro-

tating line.

Eye Protection

Keep children, bystanders, and animals 50 feet (15 meters) away. Stop unit im-

mediately if approached.

Ifsituationsoccurwhicharenotcov- eredinthismanual,usecareand goodjudgment.Ifyouneedassis-

tance,contactyourSearsService

Centre.

OPERATOR SAFETY

• Dress properly. Always wear safety

glasses or similar eye protection when operating, or performing main-

tenance, on your unit (safety glasses are available). Eye protec- tion should be marked Z87.

• Always wear face or dust mask if op- eration is dusty.

• Always wear heavy, long pants, long sleeves, boots, and gloves. Wear-

ing safety leg guards is recom- mended.

• Always wear foot protection. Do not go barefoot or wear sandals. Stay

clear of spinning line.

• Secure hair above shoulder length.

Secure or remove loose clothing or

clothing with loosely hanging ties, straps, tassels, etc. They can be caught in moving parts.

• Being fully covered also helps pro- tect you from debris and pieces of toxic plants thrown by spinning line.

• Stay Alert. Do not operate this unit when you are tired, ill, upset or un- der the influence of alcohol, drugs,

or medication. Watch what you are doing; use common sense.

• Wear hearing protection.

• Never start or run inside a closed

room or building. Breathing exhaust

fumes can kill.

• Keep handles free of oil and fuel.

UNIT / MAINTENANCE SAFETY

• Disconnect the spark plug before

performing maintenance except car- buretor adjustments.

• Look for and replace damaged or

loose parts before each use. Look

for and repair fuel leaks before use.

Keep in good working condition.

• Replace trimmer head parts that are chipped, cracked, broken, or dam-

aged in any other way before using the unit.

• Maintain unit according to recom-

mended procedures. Keep cuffing line at proper length.

• Use only 0.080 inch (2 mm) diame- ter Craftsman® brand line. Never

use wire, rope, string, etc.

• install required shield properly before

using the unit. Use only specified

trimmer head; make sure it is properly

installed and securely fastened.

• Make sure unit is assembled cor- rectly as shown in this manual.

• Make carburetor adjustments with lower end supported to prevent line

from contacting any object.

• Keep others away when making car- buretor adjustments.

• Use only recommended Craftsman®

accessories and replacement parts.

• Have all maintenance and service not explained in this manual per-

formed by a Sears Service Centre.

FUEL SAFETY

• Mix and pour fuel outdoors.

• Keep away from sparks or flames.

• Use a container approved for fuel.

• Do not smoke or allow smoking near

fuel or the unit.

• Avoid spilling fuel or oil. Wipe up all

fuel spills.

• Move at least 10 feet (3 meters)

away from fueling site before start-

ing engine.

• Stop engine and allow to cool before removing fuel cap.

• Always store gasoline in a container

approved for flammable liquids.

CUTTING SAFETY A(_-WARNING: inspect the area be-

fore each use. Remove objects

(rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line. Hard objects can

damage the trimmer head and be thrown causing serious injury.

• Use only for trimming, scalping, mow- ing, edging and sweeping. Do not use

for pruning or hedge trimming.

• Keep firm footing and balance. Do not overreach.

• Keep all parts of your body away

from muffler and spinning line. Keep engine below waist level. A hot muf-

fler can cause serious burns.

• Cut only from your right to your left.

Cutting on left side of the shield will throw debris away from the operator.

• Use only in daylight or good artificial light.

• Use only for jobs explained in this manual.

TRANSPORTING AND STORAGE

• Allow engine to cool; secure unit be-

fore storing or transporting in vehicle.

• Empty the fuel tank before storing or

transporting the unit. Use up fuel left

in the carburetor by starting the en-

gine and letting it run until it stops,

• Store unit and fuel in area where fuel vapors cannot reach sparks or open flames from water heaters,

electric motors or switches, fur-

naces, etc.

• Store unit so line limiter blade can-

not accidentally cause injury. The unit can be hung by the shaft.

• Store unit out of reach of children.

SAFETY NOTICE: Exposure to vibra-

tions through prolonged use of gaso-

line powered hand tools could cause blood vessel or nerve damage in the

fingers, hands, and joints of people

prone to circulation disorders or ab- normal swellings. Prolonged use in

cold weather has been linked to blood vessel damage in otherwise healthy

people. If symptoms occur such as numbness, pain, loss of strength,

change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool

and seek medical attention. An anti- vibration system does not guarantee the avoidance of these problems.

Users who operate power tools on a continual and regular basis must mon-

itor closely their physical condition and the condition of this tool.

SPECIAL NOTICE: This unit is equipped with a temperature limiting

muffler and spark arresting screen which meets the requirements of Cali-

fornia Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey,

Oregon, and Washington require by law that many internal combustion en-

gines be equipped with a spark arrest- ing screen. If you operate in a locale where such regulations exist, you are

legally responsible for maintaining the operating condition of these parts.

Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arresting screen will

not require any service. After 50 hours of use, we recommend that your muf-

fler be serviced or replaced by your Sears Service Centre.

CARTON CONTENTS

Check carton contents against the fol-

lowing list.

Model C944.514360

• Trimmer

• Shield

• Wing Nut (screwed onto shield)

• Container of Oil

Examine parts for damage. Do not

use damaged parts.

NOTE: If you need assistance or find

parts missing or damaged, contact your Sears Service Centre.

It is normal for the fuel filter to rattts in the empty fuel tank.

Finding fuel or oil residue on muffÊer is

normal due to carburetor adjustments

and testing done by the manufacturer,

ASSEMBLY

A(_-WARNING: If received as-

sembled, repeat all steps to ensure your unit is properly assembled and all

fasteners are secure.

ADJUSTING THE ASSIST HANDLE

A(_-WARNING: When adjusting the

assist handle, be sure it remains

above the safety label and below the

mark or arrow on the shaft.

1. Loosen wing nut on handle.

2. Rotate the handle on the shaft to an upright position; retighten wing nut.

ATTACHING SHIELD A(_-WARNING: The shield must be

properly installed. The shield provides partial protection from the risk of thrown

objects to the operator and others and

is equipped with a line limiter blade which cuts excess line to the proper

length. The line limiter blade (on under- side of shield) is sharp and can cut you.

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OP-

ERATION section.

1. Remove wing nut from shield.

2. Insert bracket into slot as shown.

3. Pivot shield until bolt passes through hole in bracket.

4. Securely tighten wing nut onto bolt.

Shield % _Iot

,_--_r_ Bracket

PIVOT Blade _2. ) NWiL_g

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT Compare the illustrations with your unit to familiarize yourseff with the location of

the various controls and adjustments. Save this manual for future reference.

Assist Handle Muffler

Shaft or Arrow

Safety Label

Shaft Mark

Trimmer Head Shield Switch _

Line Limiter \ Blade Starter Handle

STOP SWITCH

The STOP switch is used to stop the en- gine. To stop the engine, push and hold the switch in the STOP position until the

engine stops.

PRIMER BULB

The PRIMER BULB removes air from the carburetor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the

starter rope. Activate the primer bulb by pressing it and allowing it to return

to its original form.

BEFORE STARTING ENGINE

A(_-WARNING: Be sure to read

the fuel information in the safety rules

before you begin. If you do not understand the safety rules, do not

attempt to fuel your unit. Contact your Sears Service Centre.

FUELING ENGINE

,_WARNING: Remove fuel cap

slowly when refueling.

This engine is certified to operate on

unleaded gasoline. Before operation,

gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil.

Spark Plug _ Primer

STOP

CHOKE

The CHOKE helps to supply fuel to the engine to aid in cotd starting. Activate

the choke by moving the choke lever to the FULL CHOKE position. After the en-

gine attempts to start, move the choke lever to the HALF CHOKE position. Once engine has started, move the choke le-

ver to the RUN position.

We recommend Craftsman brand synthetic oil. Mix gasoline and oil at a

ratio of 40:1. A 40:1 ratio is obtained by mixing 3.2 ounces (95 ml) of oil with 1

gallon (4 litres) of unleaded gasoline. included with this trimmer is a 3.2

ounce (95 ml) container of oil. Poor the entire contents of this container into 1

gallon (4 litres) of gasoline to achieve the proper fuel mixture. DO NOT USE automotive oil or marine oil. These oils

will cause engine damage. When mixing fuel, follow instructions printed on

container. Once oil is added to gasoline, shake container momentarily to assure

that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit.

Bulb Trigger

Fuel Mix Fill Cap

+ 9 hidden pages