Instruction Manual
25cc / 1.5 cu.in. 2-Cycle
GASOLINE HEDGE TRIMMER
Model No.
0944.514320 - 22" Blade
• Safety
• Assembly
• Operation
• Maintenance
• Parts List
WARNING:Read and follow all Safety Rules and Operating
Instructions before first use of this product.
Sears Canada, Inc., Toronto, Ontario M5B 2B8
530164945 4/2/04
Warranty Statement 2 Storage 9
Safety Rules 2 Troubleshooting Chart 10
Assembly 4
Operation 5
Maintenance 7 Parts List Center Section
Service & Adjustments 8 Parts and Ordering Back Cover
UMITED TWO (2) YEAR WARRANTY FOR CRAFTSMAR _'_GAS POWERED HEDGE
TRIMMER
For two (2) years from the date of purchase Sears Canada, Inc., will repair or replace
free of charge, at Sears option, parts which are defective as a result of materials or
workmanship.
COMMERCIAL OR RENTAL USE:
If this Gas Hedge Trimmer is used for commercial application the warranty is void.
This warranty does NOT cover:
1. Expendable items which become worn during normal use, such as blades,
stader rope, spark plugs, and filter.
2. Pra-delivery setup.
3. Customer neglect; operating Hedge Trimmer without proper fuel mixture.
Warranty service is available by retumldg the Gas Hedge Trimmer to the nearest
Sears Service Centra/Department in Canada. This warranty applies only while this
product is in use in Canada.
This warranty is in addition to any statutory warranty and does not exclude or limit
legal rights you may have but shall run concu rre ntly with applicable provincial legisla-
tion. Furthermore, some provinces DO NOT allow limitation on how long an implied
warranty will last so the above limitations may not apply to you.
Sears Canada, Inc., Toronto, Ontario M5B 2R8
Emissions Statement 11
A_,DANGER: THISPOWER TOOL CAN
BE DANGEROUSI This unit can cause se-
rious injury including amputation or blind-
ness to the operator and others. The
warnings and safety instructions in this
manual must be followed to provide rea-
sonable safety and efficiency in using
this unit. The operator is responsible for
following the warnings and instructions in
this manual and on the unit. Never allow
children to use this tool.
A_,WARNING: Failure to follow all
Safety Rules and Precautions can re-
sult in serious injury.
KNOW YOUR UNIT
• Read your instruction manual care-
fully until you completely understand
and can follow all warnings and
safety rules before operating the unit.
• Restrict unit to users who understand
and will follow all warnings and safety
rules in this manual and on the unit.
PLAN AHEAD
A_,WARNING: Inspect the area be-
fore stading the unit. Remove all debris
and hard objects such as rocks, glass,
wire, etc. that can ricochet, be thrown,
or otherwise cause injury or damage
during operation.
• Always wear eye protection when op-
erating, servicing, or performing main-
tenance on unit. Wearing eye protec-
tion will help to prevent brdsh or debris
from being thrown or ricocheting into
eyes and face which can result in
blindness and/or serious injury. Eye
protection should be marked Z87.
• Wear hearing protection when using
this unit.
• Secure hair above shoulder length. Se-
cure or remove jewelry, loose clothing,
or clothing with loosely hanging straps,
ties, tassels, etc. They can be caught
in moving parts.
-2-
Safety B!ots
Glasses
,%.
Blades move Allow blades tostop
momentarily before removing
after the them from the cut.
trigger is
_i_ WARNING:
Bladesce,qthrowobjectsviolently.
• Youcanbeblindedorinjured.
• Wearsafetyglasses.
_i_ WARNING:
Hazard zone for thrown objects
• Blades can throw objects violently.
Others can be blinded or inured.
Keep peop e and anma s30 feet
(t Om) away.
_i_ WARNING:
Blades move momentarily afterthe
trigger isreleased.
• The blades can seriously cut you or
others.
• Allow blades to stop before
removing them fromthe cut.
• Stay alert. Do not operate unit when
you are tired, ill, upset, or ff you are
under the influence of alcohol, drugs,
or medication.
• Keep children, bystanders, and ani-
mals away from work area a mini-
mum of 30 feet (10 meters) when
starting or operating unit.
If situations occur which are not cov-
ered in this manual, use care and good
judgment. If you need assistance, con-
tact your Sears Service Centre.
HANDLE FUEL WITH CAUTION
• Eliminate all sources of sparks or
flame (including smoking, open
flames, or work that can cause
sparks) in the areas where fuel is
mixed, poured, or stored.
• Mix and pour fuel in an outdoor area;
store fuel in a cool, dry, well ventilated
place; use an approved, marked con-
tainer for all fuel purposes.
• Do not smoke while handling fuel or
while operating the unit.
• Do not fill fuel tank while engine is
running.
• Make sure the unit is properly as-
sembled and in good operating con-
dition.
• Avoid spilling fuel or oil. Wipe up fuel
spills before starting the engine.
• Move at least 10 feet (3 meters)
away from fuel and fueling site before
starting engine.
• Always store gasoline in a container
approved for flammable liquids.
OPERATE YOUR UNIT SAFELY
_i_DANGER: RISK OF CUT; KEEP
HANDS AWAY FROM BLADE - Blade
moves momentarily after the trigger is
released. Do not attempt to clear away
cut material when the blade is in mo-
tion. Make sure the ON/OFF switch is in
the OFF position, the spark plug wire is
disconnected, and the blade has
stopped moving before removing
jammed material from the cutting
blade. Do not grab or hold the unit by
the cutting blade.
• inspect unit before each use for
worn, loose, missing, or damaged
parts. Do not use until unit is in
proper working order.
• Keep outside surfaces free from oil
and fuel.
• Never start or run engine inside a
closed room or building. Breathing
exhaust fumes can kill.
• Avoid dangerous environments. Do
not use in unventilated areas or
where explosive vapors or carbon
monoxide build up could be present.
• Do not overreach or use from unsta-
ble surfaces such as ladders, trees,
steep slopes, rooftops, etc. Keep firm
footing and balance at all times.
• Do not raise unit above your shoul-
ders; the cutting blade can come
dangerously close to your body.
• Always keep unit in front of your body.
Keep all parts of your body away from
the cutting blade.
• Keep the cutting blade and air vents
free from debris.
-3-
• Use only for jobs explained in this
manual.
MAINTAIN YOUR UNIT PROPERLY
• Have all maintenance and service
not explained in this manual per-
formed by a Sears Service Centre.
• Disconnect spark plug before per-
forming maintenance except for car-
buretor adjustments.
• Do not use a cutting blade that is
bent, warped, cracked, broken, or
damaged in any other way. Have
worn or damaged parts replaced by
your Sears Service Centre.
• Use only recommended Craftsman®
cutting blades and replacement
pads; use of any other parts may
void your warranty and cause dam-
age to your unit.
• Empty fuel tank before storing the unit.
Use up fuel left in carburetor by stading
engine and letting it run until it stops.
• Hand carry the unit with the engine
stopped and the muffler and cutting
blade away from your body.
• Allow engine to cool, empty the fuel
tank, and secure the unit before stor-
ing or transpoding it in a vehicle.
• Do not store the unit or fuel in a
closed area where fuel vapors can
reach sparks or an open flame from
hot water heaters, electric motors or
switches, furnaces, etc.
• Store the unit so the cutting blade
cannot accidentally cause injury.
• Store in a dry area out of reach of
children.
SAFETY NOTICE: Exposure to vibra-
tions through prolonged use of gaso-
line powered hand tools could cause
blood vessel or nerve damage in the
fingers, hands, and joints of people
prone to circulation disorders or abnor-
mal swelling. Prolonged use in cold
weather has been linked to blood ves-
sel damage in otherwise healthy
people. If symptoms occur such as
numbness, pain, loss of strength,
change in skin color or texture, or loss
of feeling in the fingers, hands, or
joints, discontinue the use of this tool
and seek medical attention. An
antivibretion system does not guaran-
tee the avoidance of these problems.
Users who operate power tools on a
continual and regular basis must moni-
tor closely their physical condition and
the condition of this tool.
SPECIAL NOTICE: Your hedge trim-
mer is equipped with a temperature
limiting muffler and spark arresting
screen which meets the requirements
of California Codes 4442 and 4443. All
U.S. forest land and the states of Cali-
fornia, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington re-
quire by law that many internal com-
bustion engines be equipped with a
spark arresting screen. If you operate
a hedge trimmer in a state or locale
where such regulations exist, you are
legally responsible for maintaining the
operating condition of these parts.
Failure to do so is a violation of the law.
For normal homeowner use, the muffler
and spark arresting screen will not re-
quire any service. After 50 hours of
use, we recommend that your muffler
and spark arresting screen be replaced
by your Sears Service Centre.
CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model C944.514320
• Hedge Trimmer
• Scabbard
• 2-Cycle Engine Oil
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, contact
your Sears Service Centre.
It is normal for the fuel filter to raffle in
the empty fuel tank.
Finding fuel or oil residue on muffler is
normal due to carburetor adiustments
and testing done by the manufacturer.
ASSEMBLY
Your hedge trimmer is fully assembled;
no assembly is required.
-4-