Craftsman 944511463 Owner’s Manual

Instruction Manual
ICRRFTSMRN°J
25cc/1.5 cu.in. 2-Cycle
17 Inch Cutting Path / 0.080 In. Line
GASOLINE WEEDWACKER ®
Model No.
C944.511463
Safety
Operation
Maintenance
Parts List
Fran(_ais
WARNING:
Read and follow all Safety Rules and Operating Instructions before first use of this product.
For answers to your questions about this product: Call 7 am-7 pm, Mon.-Sat., or 10 am-7 pm, Sun.
1-800-235-5878 l,ours listed are Centra, T,me)
Sears Canada, Inc., Toronto, Ontario M5B 2B8
530163453 10/9/02
Warranty Statement 2 Storage 10 Safety Rules 2 Troubleshooting Chart 11
Assembly 4 Emissions Statement 12 Operation 5 Parts List 14
Maintenance 8 French 16
Service & Adjustments 9 Parts and Ordering Back Cover
LIMITED TWO (2} YEAR WARRANTY ON CRAFTSMAN ® GAS POWERED
WEEDWACKER _ LINE TRIMMER
For two (2) years from the date of purchase, Sears Canada, Inc., will repair or replace free of charge at Sears option parts which are defective as a result of material or workmanship. COMMERCIAL OR RENTAL USE:
Warranty on Gas Weedwacker will be 90 days from the date of purchase if used for commercial or rental purposes.This warranty does not cover:
1. Spark plugs, filter, line, spool, starter rope, and blade.
2. Damages to the motor of the unit when operated without the proper fuel
mixture (see manual).
Warranty service is available by returning the Weedwacker to the nearest Sears Ser- vice Centre/Department in Canada. This warranty applies only while this product is in
use in Canada. This warranty is in addition to any statutory warranty and does not exclude or limit
legal rights you may have but shall run concurrently with applicable provincial
legislation. Furthermore, some provinces do NOT allow limitations on how long an
implied warranty will last, so the above limitations may not apply to you. Sears Canada, Inc,, Toronto, Ontario MSB 2B8
_Ib,WARNING: When using gar- dening appliances, basic safety pre-
cautions must always be followed to reduce the risk of fire and serious
injury. Read and follow all instructions.
This power unit can be dangerous! Op- erator is responsible for following
instructions and warnings on unit and in manual. Read entire instruction manual
before using unit! Be thoroughly familiar with the controls and the proper use of
the unit. Restrict the use of this unit to
persons who have read, understand, and will follow the instructions and
warnings on the unit and in the manual.
Never allow children to operate this unit.
INSTRUCTION SAFETY INFORMATION
MANUAL ON THE UNIT
J
DANGER: Never use blades or
flailing devices. This unit is designed for line trimmer use only. Use of any
other accessories or attachments will
increase the risk of injury.
@@O
_bWARNING: Trimmer line throws objects violently. You and others can be
blinded/injured. Wear eye and leg protection. Keep body parts clear of ro-
tating line,
Eye Protection
2
Keep children, bystanders, and animals 50 feet (15 meters) away, Stop unit im- mediately if approached,
If situations occur which are not cov- ered in this manual, use care and
good judgment. If you need assis- tance, contact your Sears Service
Centre or call 1-800-235-5878. OPERATOR SAFETY
Dress properly. Always wear safety
glasses or similar eye protection when operating, or performing maintenance, on your unit (safety glasses are avail- able). Eye protection should be
marked Z87.
Always wear face or dust mask ifop-
eration is dusty.
Always wear heavy, long pants, long
sleeves, boots, and gloves. Wearing safety leg guards is recommended.
Always wear foot protection. Do not
go barefoot or wear sandals. Stay clear of spinning line.
Secure hair above shoulder length.
Secure or remove loose clothing or clothing with loosely hanging ties, straps, tassels, etc. They can be caught in moving parts.
Being fully covered also helps protect
you from debris and pieces of toxic
plants thrown by spinning line.
Stay Alert. Do not operate this unit
when you are tired, ill, upset or under the influence of alcohol, drugs, or
medication. Watch what you are do- ing; use common sense.
Wear hearing protection.
Never start or run inside a closed
room or building. Breathing exhaust
fumes can kill.
Keep handles free of oil and fuel.
UNIT / MAINTENANCE SAFETY
Disconnect the spark plug before per-
forming maintenance except carbure- tor adjustments.
Look for and replace damaged or
loose parts before each use. Look for and repair fuel leaks before use. Keep in good working condition.
Replace trimmer head parts that are
chipped, cracked, broken, or dam- aged in any other way before using
the unit.
Maintain unit according to recom-
mended procedures. Keep cutting line at proper length.
Use only 0.080 in.(2 mm) diameter
Craftsman@ brand line. Never use
wire, rope, string, etc.
Install required shield properly before
using the unit. Use only specified
trimmer head; make sure it is properly installed and securely fastened.
Make sure unit is assembled correctly as shown in this manual.
Make carburetor adjustments with lower end supported to prevent line
from contacting any object.
Keep others away when making car- buretor adjustments.
Use only recommended Craftsman accessories and replacement parts.
Have all maintenance and service not explained in this manual performed by
a Sears Service Centre.
FUEL SAFETY
Mix and pour fuel outdoors,
Keep away from sparks or flames.
Use a container approved for fuel.
Do not smoke or allow smoking near
fuel or the unit.
Avoid spilling fuel or oil. Wipe up all
fuel spills.
Move at least 10 feet (3 meters) away
from fueling site before starting em
gine.
Stop engine and allow to cool before removing fuel cap.
Always store gasoline in a container approved for flammable liquids.
CUTTING SAFETY
II_ WARNING: Inspect the area be- fore each use. Remove objects
(rocks, broken glass, nails, wire, etc.)
which can be thrown by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury.
Use only for trimming, scalping, mow- ing and sweeping. Do not use for edg- ing, pruning or hedge trimming.
Keep firm footing and balance. Do not overreach.
Keep all parts of your body away from muffler and spinning line. Keep engine below waist level. A hot muffler can
cause serious burns.
Cut only from your right to your left. Cutting on left side of the shield will throw debris away from the operator.
Use only in daylight or good artificial light.
Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
Allow engine to cool; secure unit be-
fore storing or transporting in vehicle.
Empty the fuel tank before storing or transporting the unit. Use up fuel left in the carburetor by starting the en- gine and letting it run until it stops.
3
Store unit and fuel in area where fuel vapors cannot reach sparks or open
flames from water heaters, electric
motors or switches, furnaces, etc.
Store unit so line limiter blade cannot accidentally cause injury. The unit can
be hung by the tube.
Store unit out of reach of children.
SAFETY NOTICE: Exposure to vibra- tions through prolonged use of gaso-
line powered hand tools could cause blood vessel or nerve damage in the
fingers, hands, and joints of people
prone to circulation disorders or ab- normal swellings. Prolonged use in
cold weather has been linked to blood vessel damage in otherwise healthy
people. If symptoms occur such as
numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool
and seek medical attention. An anti- vibration system does not guarantee
the avoidance of these problems. Us- ers who operate power tools on a con- tinual and regular basis must monitor closely their physical condition and
the condition of this tool.
SPECIAL NOTICE: This unit is not
equipped with a temperature limiting
muffler and spark arresting screen
which meets the requirements of Cali- fornia Codes 4442 and 4443. All U.S.
forest land and the states of California,
Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by law that many internal combustion em
gines be equipped with a spark arres- tor screen. If you operate in a locale
where such regulations exist, you are
legally responsible for installing and
maintaining the operating condition of these parts. Failure to do so is a viola- tion of the law. If a spark arresting screen is required in your area, con- tact your Sears Service Centre for the
correct kit.
CARTON CONTENTS Check carton contents against the fol-
lowing list. Model C944,511463
Trimmer
Shield
Wing Nut (screwed onto shield)
Container of Oil Examine parts for damage. Do not
use damaged parts.
NOTE: If you need assistance or find parts missing or damaged, call
1-800-235-5878. It is normal for the fuel filter to rattle in
the empty fuel tank.
Finding fuel or oil residue on muffler is normal due to carburetor adjustments
and testing done by the manufacturer.
ASSEMBLY
delbWARNING: If received as- sembled, repeat all steps to ensure
your unit is properly assembled and all fasteners are secure.
ADJUSTING THE HANDLE
E_IbWARNING: When adjusting the
handle, be sure it remains between
the trigger and the safety label.
1. Loosen wing nut on handle.
2. Rotate the handle on the tube to an upright position; retighten wing nut.
ATTACHING SHIELD
_WARNING: The shield must be
properly installed. The shield provides partial protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orientation of shield, see KNOWYOURTRIMMER illustration in OP-
ERATIONsection. 1, Remove wing nut from shield.
2, Insert bracket into slot as shown.
3. Pivot shield until bolt passes through hole in bracket.
4. Securely tighten wing nut onto bolt.
Shield /
X__" Bracket
Li__'_ NWi?g
Slot
4
Loading...
+ 9 hidden pages