Craftsman 919186950, 919176841, 919176432, 919165120, 919155611 Owner’s Manual

...
SK RS
GENERAL MANUAL FOR
CRAFTSMAN
NOTE: For identification of Re- pair Parts, see separate Parts
List Manual.
PERMANENTLY LUBRICATED
TANK MOUNTED
AIR COMPRESSOR
Record in the spaces provided. (1) The model number which can be
found on the maintenance label on the top of the motor coveroronthe
tank.
(2) The code number which can be
found on the foil label onthe rear of the air tank.
(3) The Manufacturers Number is lo-
cated onthe metaldata platewhich is welded onto the backside of the
air tank. (This data plate is painted the same color as the tank.)
IMPORTANT:
Read the Safety Guidelines and All Instructions
MG-OILFREE 1/20/94 I
Retain these numbers for future reference.
SAFETY GUIDELINES ASSEMBLY OPERATION
MAINTENANCE
TROUBLESHOOTING
REPAIR PARTS
Sears, Roebuck and Co., Chicago, IL 60684 U.S.A.
Model No.
Code No.
I Mfg. No.
TABLE OF CONTENTS
Page
WARRANTY .......................................................................................................................................... 2
SAFETY GUIDELINES ......................................................................................................................... 3
WARNING CHART ............................................................................................................................... 3
GLOSSARY ........................................................................................................................................... 5
ACCESSORIES FOR USE WITH SEARS AIR COMPRESSORS .................................................. 5
GENERAL INFORMATION .................................................................................................................. 5
DESCRIPTION OF OPERATION ....................................................................................................... 6
ASSEMBLY ........................................................................................................................................... 7
INSTALLATION AND BREAK-IN PROCEDURES ............................................................................ 7
Location of Air Compressor ........................................................................................................... 7
Lubrication and Oil ......................................................................................................................... 7
Extension Cords ............................................................................................................................. 7
Voltage and Circuit Protection ....................................................................................................... 7
Grounding Instructions ................................................................................................................... 8
Break-in Procedure ........................................................................................................................ 8
OPERATING PROCEDURES ............................................................................................................. 9
MAINTENANCE .................................................................................................................................. 10
Air Filter - Inspection and Replacement ..................................................................................... 10
Check Valve -Replacement ......................................................................................................... 10
Safety Valve - Inspection ............................................................................................................. 10
Motor ............................................................................................................................................. 10
Storage .......................................................................................................................................... 10
TROUBLESHOOTING GUIDE .......................................................................................................... 11
HOW TO ORDER REPAIR PARTS .................................................................................................. 16
FULL ONE YEAR WARRANTY ON AIR COMPRESSORS
tfthis air compressor fails due to a defect in material or workmanship within one year from the date of purchase, RETURN ITTO THE NEAREST SEARS SERVICE CENTER/DEPARTMENT THROUGHOUT THE UNITED STATES AND SEARS
WILL REPAIR IT, FREE OF CHARGE.
Ifthis air compressoris used for commercialor rental purposes, thewarranty will applyfor ninety days from the date of
purchase.
This warrantygives you specific legal rights and you may have other rights which vary from state to state.
Sears, Roebuck and Co., Sears Tower, Dept. 731CR-W, Chicago, IL 60684
SAFETY GUIDELINES
This manual contains information that is important for you to know and understand. This information relates to
protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this information,
we use the following symbols. Please read the manual and pay attention to these sections.
URGENT SAFETY INFORMATION - A HAZARD THAT WILL CAUSE
SERIOUS INJURY OR LOSS OF LIFE.
Information for preventing damage to
equipment.
HAZARDS CAN OCCUR IF EQUIPMENT IS NOT USED PROPERLY.
PLEASE READ THE FOLLOWING CHART.
WHAT TO
LOOK FOR
Hot Parts
WHAT COULD HAPPEN
Themetalcompressorcomponentssuchasmanifold, tubes,etc,becomehotwhentheaircompressorisrunning.
Ifyoutouchthem, you may be seriously burned.
IMPORTANT SAFETY INFORMATION -
A HAZARD THAT MIGHT CAUSE
SERIOUS INJURY OR LOSS OF LIFE.
NOTE
Information that you should pay special
attention to.
HOW TO PREVENT IT
Avoid contact withmetal components ofthe compressor
during or immediately after operation. Reaching under or removing portions of the plastic enclosures such as the console cover exposes hot surfaces. Allowcompressorto cool prior to servicing.
Flammable
Vapors
Air Tank
It isnormal for the motor and pressure switch to spark when compressor starts or stops. A spark can ignite vapors from gasoline or solvents, causing a fire or explosion.
Modifications to air compressor components in an
attempt to reach higher air pressure can cause the air
tank to rupture or explode.
Incomparability between tank and compressor will cause the tank to rupture.
Modifications to the airtank will cause it to weaken.
If spraying a flammable material, provide ample ven-
tilation. Never spray in a closed area. There must be a flow of fresh air at all times.
Always operate the air compressor in well-ventilated
areas, free of gasoline or other solvent vapors. Do not operate the compressor near the spray area.
Do not adjust, remove or tamper with the safety valve or pressure switch. If safety valve or pressure switch
replacement is necessary, a part with the same ratings must be used.
Never replace the air tank with a different model or a larger tank. Return to Authorized Service Center if replacement is required.
Never drill into weldor in anyway modify theairtank. Thetank may rupture or explode. Ifleaks deveop due
tocorrosion or tank is damaged, return to Authorized Service Center for replacement.
SAFETY GUIDELINES
WHAT TO
LOOK FOR WHAT COULD HAPPEN HOW TO PREVENT IT
Compressed
Air
Electricity
Compressed air can propel dust, dirt or loose particles
it comes in contact with. These propelled particles may cause serious injury or damage.
Too much air pressure applied to air tools or acces- sories can cause damage or risk of bursting.
Your air compressor is powered by electricity. Like any other electrically powered device, ifit is not used
properly it may cause electrical shock,
Never point any nozzle or sprayer toward a personor any part of the body.
Alwayswear safetygoggles or glasseswhen usingthe air compressor.
Alwaysturn the aircompressoroffbefore attachingor removing accessories.
Check the manufacturer's pressure rating for air tools and accessories. Regulator outlet pressure
must never exceed the maximum pressure rating. NOTE: IF A REGULATOR IS NOT SUPPLIED
WITH YOUR COMPRESSOR, YOU MUST
INSTALL ONE BEFORE USING AIR TOOLS AND
ACCESSORIES WITH PRESSURE RATINGS
LESS THAN 200 PSIG.
Always unplug the air compressor prior to mainte- nance or repair.
Never use the air compressor outdoors when it is raining.
Always plug the cord into an electrical outlet with the
specified voltage and adequate fuse protection.
Toxic Vapors
Unsuitable Solvents
It is normal for compressed air to contain toxic or
irritating vapors, Such vapors are harmful if inhaled.
Certain materials you are spraying (like paint, weed
killer, sand or insecticide) can be harmful ifyou inhale
them.
The solvents 1,1,1 - Trichloroethane and Methylene Chloride can chemically react with aluminum used in paint spray guns, paint pumps, etc., and cause an explosion. These solvents can also react with galva-
nized components and cause corrosion and weaken- ing of parts. This does not affect your air compressor
- but it may affect the equipment being used.
Never directly inhale the compressed air produced by this unit.
Readlabels and safety datafor allmaterialsyouspray. Follow all safety precautions.
Use amask or respirator ifthere isachanceofinhaling toxic sprayed materials. Masks and respirators have limits and will only provide protection against some
kinds and limited amounts of toxic material. Read mask and respirator instructions carefully. Consult
with asafety expert or industrial hygienist ifyou arenot sure about the use of a certain mask or respirator.
Ifthe material you intend to spray contains the solvents
listed at left (read the label or data sheet), do not use accessories that contain aluminum or galvanized pads. You must either change the material you intend to spray, or use only stainless steel spray equipment.
GLOSSARY
CFM: Cubicfeet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air delivery.
PSlG: Pounds per square inch gauge; a unit of measure
of pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the standards of the ASME.
U.L. Listed: This productis Listed by Underwriters Labora- tories, Inc. (UL). Samples of this product have been evalu- ated by UL and meet applicable UL Standards for Safety.
Cut-In Pressure: While the motor is off, air tank pressure drops as you continue to use youraccessory.When thetank
pressure drops to a certain low level the motor will restart automatically. The low pressure atwhich the motor automat-
ically re-starts is called "cut-in pressure."
Cut-Out Pressure: When you turn on your air compres- sor and it begins to run, air pressure in the air tank begins to build. It builds to a certain high pressure before the
motor automatically shuts off - protecting your air tank from pressure higher than itscapacity. The high pressure
at which the motor shuts off is called "cut-out pressure."
ACCESSORIES FOR USE WITH
SEARS AIR COMPRESSORS
The following accessories are available through full-line Sears stores.
SPRAY GUNS
BLOW GUNS
AIR CAULKING GUNS
-PNEUMATIC POWER WASH ERS
.SANDBLASTERS
-AIR BRUSHES
AIR LINE FILTERS
TIRE AIR CHUCKS
PAINT TANKS
AIR TANKS
INFLATOR KITS
QUICK CONNECTOR SETS (various sizes)
.VISCOSIMETER *AIR PRESSURE REGULATORS
OIL FOG LUBRICATORS
AIR TOOLS: Sanders Drills
Impact Wrenches
Hammers
AIR HOSE:
1/4", 5/16" or 3/8" I.D. in various lengths
GENERAL INFORMATION
You have purchased an air compressor unit consisting of
a one cylinder, single-stage air compressor pump and air tank. Included are an air hose, tire air chuck, wheels,
regulator, gauges, and handle.
This air compressor requires no oil. Now you can enjoy
all the benefits of having an air compressor without ever
having to purchase, add or change oil.
Your air compressor can be used for operating paint spray guns, air tools, caulking guns, grease guns, air brushes,
*NAILER/STAPLERS
Decking Farming
Roofing Siding Finishing
Carpentry
Upholstery Picture Framing
DRAIN CLEANER
DUSTER GUN
sandblaster, or inflating tires and plastic toys, spraying weed killers, insecticides, etc. An air pressure regulator is
required for most of the applications.
An air filter which removes moisture and dirt from com-
pressed air should be used where applicable.
These accessories can be purchased from most Sears
Parts Departments.
Loading...
+ 11 hidden pages