Craftsman 911053, 911055, 911006, 911466, 911369 Operator's Manual

OPERATOR’S MANUAL

CHARGER

Item No. 911053 — 9.6 Volt (140302001)
Item No. 911055 — 12 Volt (140302002)
Item No. 911006 — 14.4 Volt (140302003)
Item No. 911466 — 15.6 Volt (140250023)
Item No. 911369 — 16.8 Volt (140250025)
Item No. 911379 — 18 Volt (140295004)

WARNING: To reduce the risk of injury,

the user must read and understand the
operator’s manual before using this
product.

Customer Help Line: 1-800-932-3188

Sears, Roebuck and Co., 3333 Beverly Rd., Hoffman Estates, IL 60179 USA

Visit the Craftsman web page: www.sears.com/craftsman

987000-133
7-20-07 (REV:01)

Save this manual for future reference

For use with Craftsman 9.6, 12, 14.4,

15.6, 16.8, and 18 Volt battery packs
as indicated

BATTERIES SOLD SEPARATELY

WARRANTY

ONE YEAR FULL WARRANTY ON CRAFTSMAN TOOL
If this Craftsman tool fails to give complete satisfaction within one year from date of purchase, RETURN IT TO THE

NEAREST SEARS STORE IN THE UNITED STATES, and Sears will replace it, free of charge.

If this Craftsman tool is used for commercial or rental purposes, this warranty applies for only 90 days from the date of
purchase.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

WARNING! READ AND UNDERSTAND ALL

INSTRUCTIONS. Failure to follow all instructions

listed below, may result in electric shock, fire
and/or serious personal injury.

 Before using battery charger, read all instructions

and cautionary markings in this manual, on battery
charger, battery, and product using battery to prevent
misuse of the products and possible injury or damage.

CAUTION: To reduce the risk of electric shock

or damage to the charger and battery, charge
only nickel-cadmium rechargeable batteries as
specifically designated on your charger. Other
types of batteries may burst, causing personal
injury or damage.

 Do not use charger outdoors or expose to wet or

damp conditions. Water entering charger will increase

the risk of electric shock.

 Use of an attachment not recommended or sold

by the battery charger manufacturer may result in
a risk of fire, electric shock, or injury to persons.

Following this rule will reduce the risk of electric shock,
fire, or serious personal injury.

 Do not abuse cord or charger. Never use the cord to

carry the charger. Do not pull the charger cord rather
than the plug when disconnecting from receptacle.
Damage to the cord or charger could occur and create
an electric shock hazard. Replace damaged cords
immediately.

 Make sure cord is located so that it will not

be stepped on, tripped over, come in contact
with sharp edges or moving parts, or otherwise
subjected to damage or stress. This will reduce the

risk of accidental falls, which could cause injury, and
damage to the cord, which could result in electric
shock.

 Keep cord and charger from heat to prevent

damage to housing or internal parts.

 Do not let gasoline, oils, petroleum-based products,

etc., come in contact with plastic parts. They contain

chemicals that can damage, weaken, or destroy plastic.

 Do not operate charger with a damaged cord or

plug, which could cause shorting and electric shock. If

damaged, have the charger replaced by an authorized
serviceman.

 Do not operate charger if it has received a sharp

blow, been dropped, or otherwise damaged in any
way. Take it to an authorized serviceman for electrical

check to determine if the charger is in good working
order.

 Do not disassemble charger. Take it to an authorized

serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.

 Unplug charger from outlet before attempting any

maintenance or cleaning to reduce the risk of
electric shock.

 Disconnect charger from the power supply when

not in use. This will reduce the risk of electric shock

or damage to the charger if metal items should fall into
the opening. It also will help prevent damage to the
charger during a power surge.

Risk of electric shock. Do not touch uninsulated

portion of output connector or uninsulated battery
terminal.

Plug charger into outlets on the wall or floor only.

Do not plug charger into overhead outlets.

 Save these instructions. Refer to them frequently

and use them to instruct others who may use this
tool. If you loan someone this tool, loan them these
instructions also to prevent misuse of the product and
possible injury.

2