Craftsman 78615160 Owner’s Manual

SEARS

owner's

manual

MODEL NO.

786.15160

CAUTION: For safe use

of this product read and
follow all instructions

before use.

I:RI:IFTSMRN

• Operating
Instructions

• Repair Parts

STAINLESS
STEEL

SPRAYER

2.0 Gallon Model

WARNING: Do not use chlorine or
chlorine based solutions in stainless

FUNNEL TOP

MODEL NO, CAPACITY

_86,15160 2,0 Gallon

Pdnted in U.S.A. 2-1457-16 (A)

steel sprayers due to chemical
attack.

Sears, Roebuck and Co.

Hoffman Estates, IL 60179 U,S.A.

,_ RULES FORSAFE OPERATION _lk

• Always read Owner's Manual before using sprayer.

I Always wear protective goggles, gloves, and clothing.
Q Never spray flammable materials.

• Always read and follow chemical container label instructions
before use.

• Never leave sprayer in the sun.

• Always release pressure in sprayer before disassembling.

• Never store material in tank.

• Always release pressure, empty and clean sprayer after use.

• Never modify sprayer from original condition.

WARNING

IMPROPERUSEORFAILURETOFOLLOWINSTRUCTIONSCANRESULTIN

EXPLOSIONCAUSINGMAJORINJURY.FORSAFEUSEOFTHISPRODUCTYOU
MUSTREADANDFOLLOWALLINSTRUCTIONSBEFOREUSE,

PRE-USE SPRAYER SAFETY INSPECTION:

1.Check tightness of hose clamp with screwdriver to be sure hose
is securely attached to the tank outlet nipple.

2. Inspect hose for deterioration, cracks, softness or brittleness, If
any of these conditions are found, replace hose before using.

Replace with original manufacturer's parts only.

3. Remove pump {SEEPRESSURE RELEASE INSTRUCTIONS)

4. }nspect interiorand exterior of tank for signsof deterioration (i,e.

rust, cracks, bubbling and/or pitting) of body and bottom. Any
sign of deterioration indicates possible tank weakening and

could result inexplosive bursting under pressure. If any of these

signs are found, DISCARD TANK IMMEDIATELY.AND REPLACE,

CAUTION: Do not attempt to patch leaks, etc. as this could result in serious

injury,

5. Forpressure testing orto become familiarwith sprayeruse,u=e

water only, and follow steps1,2,5,6 and 7 ofFILLING

INSTRUCTIONS.

6. Once unit isfilled with water, inspect for leaks by following
PRESSURIZING INSTRUCTIONS, except that in step 2, only pump
piunger 8 to 10strokes.

7. After inspection is completed, pump p[unger until it works hard
and lock handle.

8. (FOLLOW SPRAYING INSTRUCTIONS) to verify desired spraying
patterns and practice spraying.

9. Torelease pressure (SEE PRESSURERELEASING INSTRUCTIONS)

10. Emptytank.

11.Proceedwith filling, pressurizing and sprayinginstructions with desired
chemical solution.