Craftsman 73919 Owner's Manual

RechaRging Utility light

1. Turn ﬁxture OFF.

2. When charging with AC adapter, insert the battery charger plug into the jack on the worklight handle and the other end into a standard 110-120V AC outlet.

NOTE: Batteries will reach full charge in about 2 hours. LED indicator light glows red while the batteries are charging.

hanging Utility light

1. Hanging hook can rotate 360°.

Maintenance

Before performing any maintenance, ALWAYS unplug worklight. Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth and a mild soap, if needed. Be sure not to get the electrical lug wet. NEVER submerge any part of the worklight in any solution to clean it. DO NOT USE solvents such as gasoline, turpentine, etc. to clean unit. Aerosols and other chemicals may fog the clear polycarbonate lens.

One yeaR FUll WaRRanty On WORklight

If this product fails due to a defect in material or workmanship within one year from the date of purchase, RETURN IT TO YOUR NEAREST SEARS STORE OR CRAFTSMAN OUTLET IN THE UNITED STATES, and it will be replaced free of charge.

This warranty applies for only 90 days from the date of purchase if this Craftsman Worklight is used for commercial or rental purposes. This warranty gives you speciﬁc legal rights, and you may also have other rights, which vary from state to state.

Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA Assembly or operation questions? Call 1-800-469-4663 www.craftsman.com

Printed in China

07/2014 825-0972

Owner’s Instructions

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS!

DANGER - TO REDUCE THE RISK OF ELECTRIC FIRE OR ELECTRIC

SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS.

WARNING - When using electrical ﬁxtures, base precautions

should always be followed, including the following:

1. Read all instructions before using the ﬁxture.

2. DO NOT handle this ﬁxture or try to plug it in when your hands are wet or damp

or when you are standing on a wet or damp surface or in water.

3. To reduce the risk of injury, close supervision is necessary when an ﬁxture is used near children.

4. ONLY USE attachments recommended or sold by the manufacturer.

5. DO NOT use outdoors. This ﬁxture is intended for use as general indoor lighting.

6. DO NOT use in potentially dangerous locations, such as ﬂammable or

explosive atmospheres.

7. DO NOT use in potentially dangerous locations, such as ﬂammable or explosive atmospheres.

LED Work Light MoDEL No. 73919

8. To reduce the risk of electric shock, do not put in water or other liquid. Do not place or store appliance where it can fall or be pulled into a tub or sink. NEVER ATTEMPT TO PICK UP

PLUGGED-IN APPLIANCES WHEN THEY FALL INTO WATER BECAUSE FATAL ELECTROCUTION COULD RESULT.

9. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

10. Do not operate ﬁxture if it has received a sharp blow, been dropped, or otherwise damaged in any way.

11. The direct plug-in charger is intended to be correctly oriented in a vertical or ﬂoor mount position.

12. This ﬁxture MUST ALWAYS BE USED in accordance with all electrical and safety codes and ordinances, including the most recent National Electric Code (NEC) and with the Occupational Safety and Health Administration (OSHA) Volume 1 on General Industry Standards and interpretations.

13. DO NOT replace batteries.

14. DO NOT dispose of this product in ﬁre. Batteries inside this product may explode or leak.

15. NiMH batteries must be disposed of in accordance with local waste ordinances and regulations.

16. DO NOT short the positive-negative terminals together.

17. DO NOT work on this battery pack.

18. DO NOT disassemble ﬁxture. The ﬁxture does not have any user serviceable parts.

19. This product is not intended to be repaired by service personal in case of failure or component defect (unit can be thrown away).

20. This product must not be disposed of together with domestic waste. This product has to be disposed at an authorized place for recycling of electrical and electronic appliances.

21. NEVER operate the light with the clear protective lens removed.

22. KEEP AWAY from excessive heat or ﬂame.

23. DO NOT look directly into the light.

24. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

 • Reorientorrelocatethereceivingantenna.

 • Increasetheseparationbetweentheequipmentandreceiver.

 • Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.

 • Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

OpeRatiOn

1. Press switch in the handle up to turn the LED lights on high output.

2. Press switch in the handle down to turn the LED lights on low output.

3. Press switch to the middle to turn the ﬁxture OFF.