Craftsman 706592150 Owner’s Manual

CRAFTSMAN °

Operator's Manual

PROJECT CENTER

SAFETY RULES AND WARNINGS:

• DO NOT stand on this product. You may fall which may cause personal injury.

• WEAR SAFETY GLASSES when removing or repositioning the slides. The tool
could slip which may cause personal injury.

• When moving this product, do not pull it. Push the product to prevent personal injury.

• USE THE BRAKES when not moving this product. This will prevent the product from
rolling, which may cause personal injury or product damage.

• BE CAREFUL when opening more than one drawer. The product may become
unstable and tip, which may cause personal injury or product damage.

• DO NOT mount this product on a truck bed or any other moving object. This may
cause personal injury or product damage.

• DO NOT step in the drawers. You may fall which may cause personal injury.

• Appropriately secure this product before moving it with a forklift.

• DO NOT tow with power equipment. The product could tip, which may cause
personal injury or product damage.

• DO NOT alter this product in any manner. For example, do not weld external
lockbars or attach electrical equipment. This may cause product damage or personal

injury.

• Keep the product on level surfaces. The product may become unstable and tip if
stored or moved on an un-level surface, which may cause personal injury or product
damage.

• Lock the drawers before moving this product. The drawers could come open and
make the product unstable and tip, which may cause personal injury or product
damage.

• The maximum weight for each drawer should be no more than 25 pounds.

• The maximum product weight, including contents, cannot exceed 400 pounds.

Pleaseindicate the following information from the servicepart drawing provided.

Model Number:

Model Description:

CAUTION:

Read and follow all Safety Rules and Operating Instructions before

first use of this product. Retain this document for future reference.

Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA

F1431

Call 1-800-4MY-HOME (1-800-469-4663) for Service Parts.
Refer to Service Parts Drawingfor full listing of Service Parts.

Tools Required:

Hardware Included:

Socket Wrench
3/8" Socket

7/16" Socket
3" Socket Extension

(16)

(16)

CASTER INSTALLATION:

NOTE: Use adequate manpower for this

operation.

• Lay the unit on its back, use packaging

material to protect the paint finish

• Attach the casters to unit using (4) 1/4-
20 x 7/16" screws and (4) 1/4-20 nuts
Mount both swivel casters on the same

side of the unit Wrench tighten

\\\

• Return the unit to its upright position.

PLASTIC TOP INSTALLATION:

• Remove the top two drawers to gain
access to the holes pre-drilled in the

metal top.

• Attach using (4) #14-10 x 5/8 screws.

DRAWER REMOVAL:

• Fully extend the drawer. Push it back a
quarter of an inch.

• Insert a screwdriver into the slot in the
slide and push in on the stop until it

clears the lance. Repeat the procedure
on the other slide and remove the

drawer.

Slot

..... Lubricate

y-Stop

To reinstall the drawer, pry the stop far
enough out to engage the lance (3/16" to

1/4") and push the drawer onto the
slides until the stops pass over the

lances.

• For casters, use high quality bearing
grease, (yearly).

• Lubricate the slides, (twice yearly).

• Periodically the drawer fronts, drawer
trim, and other surfaces should be

cleaned with a mild detergent and water.

• Auto wax wilt preserve the storage unit's
luster finish. Apply the wax as to a car.
The wax wilt also help protect the unit

against scratches.

• Grease and oil can be removed with
most standard cleaning fluids. For

safety, use a nonflammable cleaning

fluid.

3 4