Craftsman 706331470 Owner’s Manual
OPERATOR'S MANUAL
I €RAFTSM AH°l
WORKBENCH
10132 (RED)
10138 (BLACK)
CAUTION: Read and follow all Safety Rules and Operating Instructions before first use of this product.
Retain this document for future reference.
Distributed by Sears Brands Management Corporation., Hoffman Estates, IL 60179 F1700
fSAFETY WARNINGS AND CAUTIONS:
• Use appropriate safety equipment when using power and hand tools. Failure to do so may cause personal injury or product
damage.
• Use adequate manpower when assembling and moving this unit. Failure to do so may cause personal injury or product
damage.
DO NOT stand on this product. You may fall which may cause personal injury.
DO NOT mount this product on a truck bed or any other moving object. This may cause personal injury or product damage.
Appropriately secure this product before moving it with a forklift.
DO NOT alter this product in any manner. For example, do not weld external Iockbars or attach electrical equipment. This
may cause product damage or personal injury.
Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an un-level surface,
which may cause personal injury or product damage.
DO NOT step in the drawers. You may fall which may cause personal injury.
Maximum combined weight limit not to exceed 1,450 pounds. If the limit is exceeded, the product could collapse and cause
personal injury or product damage.
k.
Tools Required:
Parts Included: Hardware Included:
Socket wrench
3" socket extension
7/16" Deep-well Socket
3/8" Wrench
Drill
1/8" Drill bit
Square
Tape measure
B
C
Label Description Quantity 1/4-20 x 5/8
A Side 2 carriage bolt
B Rail 3
C Backsptash 1
D Workbench top 1
Leveling
foot
5/16
washer
1/4-20
flange nut
14-10 X 5/8
Rex screw
AA(12)
BB(12)
CC(12)
DD(11 )
EE(4)
A(2) .....
Call 1-800-4MY-HOME (1-800-469-4663) for Service Parts.
efer to Service Parts Drawing for full listing of Service Parts.
STEP (1):
AA(8) BB(8) CC(8)
f-
f
STEP (2):
AA(4)
BB(4)
\_ .J
CC(4)
EE(4)
NOTE: While unpackaging the workbench, save packaging
materials to use as a scratch free surface.
• Assemble (2) feet (EE) in each side (A). Some adjustments
may be necessary after workbench is in desired position.
//._ ............. _.
\ f EE
NOTE: One rail used in this step should have the CRAFTSMAN
Logo. The side where rail with the CRAFTSMAN logo is used will
become the front.
• Flanges of rails (B) should point in. Notches should be up,
• Assemble (2) sides (A) and (2) rails (B), as shown, using (8)
bolts (AA), (8) washers (BB), and (8) nuts (CC).
• Attach remaining rail (B) in top back set of holes in (2) sides
(A) as shown, using (4) bolts (AA), (4) washers (BB), and (4)
nuts (CC). Flanges of rail (B) should point out. Notches should
be on top.
CC
AA
B
.........Flanges
point out
Front
Back
.............. on top
AA
CC
Front on top
(EE)
A
Notches
ges
pointin
Back
"B
• Square the unit and wrench tighten all fasteners.
,J
Loading...