Craftsman 706149280, 706149290 Owner’s Manual

OPERATOR'S MAN UAL

Workbench

Please indicate the following information from the service part drawing provided.

Model Number:

Model Description:

*Product you purchased may vary from picture shown.

Caution: Read and follow all Safety Rules and Operating Instructions before first
use of this product. Retain this document for future reference.

Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA

F1649

/SSAFETY WARNINGS AND CAUTIONS:

• Use appropriate safety equipment when using power and hand tools. Failure to do so may cause personal injury or product

damage.

• Use adequate manpower when assembling and moving this unit. Failure to do so may cause personal injury or product
damage.

• DO NOT stand on this product. You may fall which may cause personal injury.

• DO NOT mount this product on a truck bed or any other moving object. This may cause personal injury or product damage.

• Appropriately secure this product before moving it with a forklift.

• DO NOT alter this product in any manner. For example, do not weld external Iockbars or attach electrical equipment. This
may cause product damage or personal injury.

• Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an un-level surface,

which may cause personal injury or product damage.

• DO NOT step in the drawers. You may fall which may cause personal injury.

• Maximum combined weight limit not to exceed 1,450 pounds. If the limit is exceeded, the product could collapse and cause
personal injury or product damage.

Tools Required:

Socket wrench
3" socket extension

7/16" Deep-well Socket
3/8" Wrench

Drill
1/8" Drill bit
Square
Tape measure

D

Hardware Included

AA(12)

BB(12)

CC(12)

DD(11)

EE(4)

B(3)

A(2) ......

Call 1-800-4MY-HOME (1-800-469-4663) for Service Parts.

efer to Service Parts Drawing for full listing of Service Parts.

f

r

STEP (1):

AA(8) BB(8) CC(8)

\j

EE(4)

Assemble (2) (EE) in each (A). Some adjustments may be

necessary after workbench is in desired position.

\\\\\\\\\\

STEP 2:

AA(4)

BB(4)

CC(4)

• Attach remaining (B) in top back set of holes in (2) (A) as
shown, using (4) (AA), (4) (BB), and (4) (CC). Flanges of (B)
should point out.

• Finger tighten.

CC

AA

• Place workbench top, (D) with coated side down. (Use
packaging material to prevent scratches.

Note: The rail (B) with the label should be placed toward the front
of the unit with the label upside down.

• Assemble (2) (A) and (2) (B), as shown, using (8) (AA), (8)
(BB), and (8) (CC). Flanges of (B) should point in. Notches
should be up.

• Finger tighten.

(BE)

............... on top

AA

\

CC _\

\

A

B

.........Flanges

point out

Front

Back

• Square the unit and wrench tighten all fasteners.

Notches

Front on top

Flanges
point in

Back _B

,J