Craftsman 706149250, 706149400 Owner’s Manual

OPERATOR'S MANUAL

t_

Workbench 6' & 8'

PART# F1725

Please indicate the following information from the service part drawing provided.
Model Number:

Model Description:
*Product you purchased may vary from picture shown.

Caution: Read and follow all Safety Rules and Operating Instructions before first
use of this product. Retain this document for future reference.

Distributed by Sears Brands Management Corporation., Hoffman Estates, IL 60179

F1725

SAFETY WARNINGS AND CAUTIONS:

• Use appropriate safety equipment when using power and hand tools. Failure to do so may cause personal injury or product

damage.

• Use adequate manpower when assembling and moving this unit. Failure to do so may cause personal injury or product
damage.

• DO NOT stand on this product. You may fall which may cause personal injury.

• DO NOT mount this product on a truck bed or any other moving object. This may cause personal injury or product damage.

• Appropriately secure this product before moving it with a forklift.

• DO NOT alter this product in any manner. For example, do not weld external Iockbars or attach electrical equipment. This
may cause product damage or personal injury.

• Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an un-level surface,

which may cause personal injury or product damage.

• DO NOT step in the drawers. You may fall which may cause personal injury.

• Maximum combined weight limit not to exceed 1,450 pounds. If the limit is exceeded, the product could collapse and cause

personal injury or product damage.

Tools Required:

Socket wrench
3" socketextension

7/16" Deep-well Socket
3/8" Wrench

Drill

1/8" Drill bit
Square
Tape measure

C

E

(Purchased
Separately)

D

Hardware Included

AA(30)

BB(30)

l C(30)

DD(15)

EE(4)

B(3)

A(2)_

Note: Not all hardware is used for
the 6' workbench.

Call 1-800-4MY-HOME (1-800-469-4663)for Service Parts.

efer to ServiceParts Drawing for full listing of Service Parts.

f

STEP (3):

STEP (1):

EE(4)

Assemble (2) (EE) in each (A). Some adjustments may be
necessary after workbench is in desired position.

/

A

EE

STEP (2):
For 6' Workbench skip this step

AA(8) _ BB(8) _

• Place workbench top (Purchased Separately), (D) with top side
down. (Use packaging material to prevent scratches.

Note: The rail (B) with the label should be placed toward the front
of the unitwith the label upside down.

• Assemble (2) (A) and (2) (B), as shown, using(8) (AA), (8)

(BB), and (8) (CO). Flanges of (B) should point in.Notches
should be up.

• Fingertighten.

CC BB on top

cc(8)

/

AA

on top

Flanges

pointin

Back

B

AA(16) BB(16)

• Assemble (1) (B) and (1) (D), as shown, using (8) (AA), (8)
(BB), and (8) (CC).

• Repeat for other top support rail.

• Finger tighten.

BB

CC

D

CC(16)

STEP (4):

AA(6) _) BB(6) _]

• Attach remaining (B) intop back set ofholes in (2) (A) as

shown,using (4) (AA), (4) (BB), and (4) (CC). Flangesof (B)
shouldpointout.

• Attach remaining hardware in bottom holes intop front set of
holes as shown in illustration.

• Fingertighten.

CC(6)

)