Craftsman 358798520 Owner’s Manual

_6 Operator's Manual
CRRFTSMRN_
1.4 cu. in./21cc 2-Cycle / .065 In. Line
16 Inch Cutting Path
GASOLINE WEEDWACKER
Model No.
358.798520
®
H
WARNING:
Read and follow all Safety Rules and Operating Instructions before first use of this product.
For answers to your questions about this product:
Call 7 am-7 pm, Mon-Sat; Sun, 10 am-7 pm
1-800-235-5878
Sears, Roebuck and Co., Hoffman Estates IL 60179 USA
530..084025 3/13/96
H
H
Warranty Statement 2 Service & Adjustments 9 Safety Rules 2 Storage 11
Assembly 4 Troubleshooting Chart 12 Operation 5 Spanish 16
Maintenance 8 Parts and Ordering Back
FULL ONE YEAR WARRANTY ON CRAFTSMAN GAS POWERED
WEEDWACKER ® LINE TRIMMER.
For one year from the date of purchase, when this Craftsman Gas Powered Weedwacker® Line Trimmer is maintained, lubricated, and tuned up according to the operating and maintenance instructions in the operator's manual, Sears will repair, free of charge, any defect in material or workmanship.
This warranty excludes nylon line, spark plug, and air filter, which are expendable parts and become worn during normal use.
If this Weedwacker® Line Trimmer is used for commercial purposes, this warranty applies for only 90 days from the date of purchase. If this Weedwacker® Line Trim- mer is used for rental purposes, this warranty applies for only 30 days from the date
of purchase. This warranty applies only while this product is in use in the United States.
WARRANTY SERVICE IS AVAILABLE BY RETURNING THE WEEDWACKER® LINE
TRIMMER TO THE NEAREST SEARS SERVICE CENTER IN THE UNITED STATES.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co. Dept. D/817WA Hoffman Estates, IL 60179
WARNING: When using gardening appliances, basic safety precautions must always be followed to reduce the risk of fire and serious injury Read and
follow all instructions
This power unit can be dangerous!
Ooeretor is responsible for following instructions and warnings on unit and
in manual. Read entire Operator's Manual before using unit! Be thorough- ly familiar with the controls and the
proper use of the unit. Restrict the use of this unit to persons who have read,
understand, and will follow the instruc- tions and warnings on the unit and in
lhe manual. Never allow children to
operate this unit.
Safety information on the unit
DANGER: Never use blades or flailing
devices. This unit is designed for line
trimmer use only. Use of any other ac- cessories or attachments will increase
the risk of injury.
000
WARNING: Trimmerlinethrowsob- jects violently. Youand otherscan be
blinded/injured.Wear eyeand leg
If situations occur which are not cov- ered in this manual, use care and
good judgement, ff you need assis- tance, contact Sears Service or call
f-800-235-5878.
OPERATOR SAFETY
Always wear safety eye protection.
Always wear long pants, long
sleeves, boots, and gloves. Wearing safety tog guards is recommended. Do not go barefoot or wear sandals. Stay clear of spinning line.
Secure hair above shoulder length. Secure or remove loose clothing or
clothing with loosely hanging ties, straps, tassels, etc. They can be
caught in moving parts,
Do not operate when you are tired, ill, or under the influence of alcohol,
drugs, or medication.
Wear hearing protection if you use
unit for more than 1-1/2 hours per day.
Never start or run inside a closed
room or building. Breathing exhaust
fumes can kill.
Keep handles free of oil and fuel.
UNIT / MAINTENANCE SAFETY
Disconnect the spark plug before performing maintenance except car-
buretor adjustments.
Look for and replace damaged or loose parts before each use. Look
for and repair fuel leaks before use.
Keep in good working condition.
Replace trimmer head parts that are
chipped, cracked, broken, or dam- aged in any other way before using
the unit.
Make sure unit is assembled correct- ly as shown in this manual.
Make carburetor adjustments with rower end supported to prevent line
from contacting any object.
Keep others away when making car- buretor adjustments.
Use only recommended Craftsman
accessories and replacement parts.
FUEL SAFETY
Mix and pour fuel outdoors.
Keep away from sparks or flames.
Use a container approved for fuel.
Do not smoke or allow smoking near fuel or the unit.
Wipe up all fue! spills.
Move at least 10 feet (3 meters) away from fueling site before starting
engine.
Stop engine and allow to cool before removing fue] cap.
CUTTING SAFETY
Use only for trimming, mowing, edg-
ing, and sweeping. Do not use for pruning or hedge trimming.
Inspect the area before each use. Remove objects (rocks, broken
glass, nails, wire, etc.) which can be thrown by or become entangled in
line. Hard objects can damage the trimmer head and be thrown causing
serious injury.
Keep firm footing and balance. Do not overreach.
Keep all pads of your body away from muffler and spinning line. Keep
engine below waist level. A hot muf- fler can cause serious burns.
Cutting on left side of the shield will
throw debris away from the operator.
TRANSPORTING AND STORAGE
Allow engine to cool; secure unit be- fore storing or transporting in vehicle.
Empty the fuel tank before storing or
transporting the unit. Use up fuel left
in the carburetor by starling the en- gine and letting it run until it stops.
Store unit and fuel in area where fuel vapors cannot reach sparks or open
flames from water heaters, electric motors or switches, furnaces, etc.
Store unit so line limiter cannot acci- dentally cause injury.The unit can be hung by the tube.
Store unit out of reach of children.
If situations occur which are not cov- ered in this manual, use care and
good judgment. If you need assis- tance, call 1-800-235-5878.
SPECIAL NOTICE: This unit is not
equipped with a temperature limiting
muffler and spark arresting screen
which meets the requirements ofCali-
fornia Codes 4442 and 4443. All U.S. forest land and the states of California,
Idaho. Maine. Minnesota, New Jersey, Oregon, and Washington require by
law that many internal combustion en- gines be equipped with a spark arres-
tor screen. If you operate in a locale
where such regulations exist, you are
3
legallyresponsible for installing and
maintaining the operating condition of these parts. Failure to do so is a viola- tion of the law, Refer to the MAINTE-
NANCE section inthis manual.
SPECIAL NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage
in the fingers, hands, and joints of people prone to circulation disorders or
abnormal swellings. Prolonged use in cold weather has been linked to blood
vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength,
change in skin color or texture, or loss of feeling in the fingers, hands, or
joints, discontinue the use of this tool
and seek medical attention. An anti-
vibration system does not guarantee the avoidance of these problems. Us- ers who operate power tools on a con- tinual and regular basis must monitor
closely their physical condition and the
condition of this tool.
CARTON CONTENTS Check carton contents against the fol-
lowing list.
Model 358.798520
Trimmer
Shield
Container of Oil Examine parts for damage. Do not use
damaged parts. NOTE: II you need assistance or find
parts missing or damaged, call 1-800-235-5878.
It is normal for the fuel filter to rattle in
the empty fuel tank.
Finding fuel or oil residue on muffler is normal due to carburetor adjustments
and testing done by the manufacturer.
ASSEMBLY
WARNING: If received assembled,
repeat all steps to ensure your unit is
properly assembled and all fasteners are secure.
ADJUSTING THE HANDLE
WARNING: When adjusting the han- dle, be sure if remains between the trigger and the safety label.
Loosen wing nutor knob on handle.
Rotate the handle on the tube to an
uprightposition; retighten wing nut.
ATTACHING SHIELD WARNING: The shield mustbe properly
instalred.The shield provides partia!
protection from the risk of thrown objects to the operator and others and is equipped with a line limiter which cuts excess line to the proper length. The line limiter {on underside of shield) is sharp and can cut you. For proper orientation.
see illustration in Operation section.
Remove wing nut from shield
Insert bracket into slot as shown.
Pivot shield until bolt Dasses through hole in bracket.
Securely tighten wing nut onto bolt.
Slot
/
Bracket
/
_ Wing
Nut
4
KNOW YOUR TRIMMER
READ THIS OPERATOR'S MANUAL AND SAFETY RULESBEFORE OPERATINGYOUR UNIT,Compare the illustrations with your unit to familiarize yourself with the loca-
tion of the various controls and adjustments. Save this manual for future refer- ence.
Assist Handle
Tube
On/Stop _Thro_le Trimmer Switch Head
Starter Rope Choke Shield
Primer Fuel Mix _r,......._._ Limiter
Bulb Fill Cap Blade
ON/STOP SWITCH
The On/Stopswitch is used to stop the engine. Press and hold the switch to
stop the unit.
PRIMER BULB
The primer bulb removes air from the
fuel lines and fills them with fuel. This allows you to start the engine with few-
er pulls on the starter rope. Activate
the primer bulb by pressing it and al-
Powing it to return to its original form.
CHOKE
The choke helps to supply fuel to the
carburetor during starting. This allows you to start a cold engine. Activate the choke by moving the choke lever to
the Full position. After the engine has started, move the choke to the Off
position.
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel information in the safety rules before
you begin. If you do not understand
the safety rules, do not attempt to fuel your unit. Call 1-800-235-5878,
Lever
FUELING ENGINE
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good quality 2-cycle air-cooled engine oil
We recommend Craftsman brand oil. Mix gasoline and oilat a ratio of 40:1
{A 40:1 ratio is obtained by mixing3.2 ounces of oil with 1 gallon of unleaded gasoline). DO NOT USE automotive oil
or boat oil. These oils will cause
engine damage. When mixing fuel. follow instructions printed on container.
Once oil is added to gasoline, shake
container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. IMPORTANT
Experience indicates that alcohol blended fuels (called gasohol or using
ethanol or methanoil can attract mois-
ture which leads to separation and
formation of acids during storage. Acidic gas can damage the fuel sys- tern of an engine while in storage.
Debris
To avoid engine problems, empty the fuel system before storage for 30 days
or longer. Drain the gas tank, start the engine and let it run until the fuel lines
5
Line
Loading...
+ 10 hidden pages