Global LCD Panel Exchange Center
www.panelook.com
Chhuunngghh
C
Teecchhnniiccaall SSppeecciiffiiccaattiioonn
T
To :
PROVIEW
waa PPiiccttuurree
w
Tuubbeess,,
T
Lttdd..
L
Date : 2009/02/09
CPT TFT-LCD
CLAB 215FA01
ACCEPTED BY
APPROVED BY CHECKED BY PREPARED BY
TFT-LCD Plant
Product Planning
Neptune Kang
Product Planning Management General Division
CHUNGHWA PICTURE TUBES, LTD.
1127 Hopin Rd., Padeh, Taoyuan, Taiwan 334, R.O.C.
TEL: +886-3-3675151 FAX: +886-3-377-3054
Tristan Wang
Management
General Division.
Doc. No: CLAB215FA01–Proview–SPEC-Ver-20090209 Issue Date: 2009/02/09
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
CPT CHUNGHWA PICTURES TUBES, LTD.,
Table Of Content
NO Table of Content Note
1 OVERVIEW P.3
2 ABSOLUTE MAXIMUM RATINGS P.4
3 OPTICAL CHARACTERISTICS P.5
4 BLOCK DIAGRAM P.7
5 INTERFACE PIN CONNECTION P.9
6 ELECTRICAL CHARACTERISTICS P.10
7 INTERFACE TIMING P.12
8 OUTLINE DIMENSION P.15
ʳ
CPT Confidential ʳ CHUNGHWA PICTUER TUBES, LTD. CLAB215FA01-PROVIEW -V1-20090209
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Page: 2/16
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
CPT CHUNGHWA PICTURES TUBES, LTD.,
1. OVERVIEW
CLAB215FA01 is 21.5” color TFT-LCD (Thin Film Transistor Liquid Crystal Display) module composed
of LCD panel, driver ICs and control circuit. By applying 6 bit digital data, 1920×1080, 16.7M-color
images are displayed on the 21.5” diagonal screen. Input power voltage is 5.0V for LCD driving. General
specification is summarized in the following table:
ITEM SPECIFICATION
Display Area(mm) 476.64 (H) × 268.11 (V) (21.53-inch diagonal)
Number of Pixels 1920 (H) × 1080(V)
Pixel Pitch(mm) 0.24825 (H) × 0.24825 (V)
Color Pixel Arrangement RGB vertical stripe
Display Mode Normally white, TN
Number of Colors 16.7M(6bits+Hi-FRC)
Viewing Angle(H/V) 170/160 (Typ.)
Surface Treatment Anti-glare, 3H
ʳ
CPT Confidential ʳ CHUNGHWA PICTUER TUBES, LTD. CLAB215FA01-PROVIEW -V1-20090209
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Page: 3/16
www.panelook.com
Global LCD Panel Exchange Center
CPT CHUNGHWA PICTURES TUBES, LTD.,
2. ABSOLUTE MAXIMUM RATINGS
ITEM SYMBOL MIN. MAX. UNIT REMARK
Power Supply Voltage for LCD VCC 0 6 V
static electricity
Operation Temperature Top 0 50
Storage Temperature Tstg -20 60
Delayed Discharge Time TD -- 1 sec *6)
[Note]
1).The relative temperature and humidity range are as below sketch, 90%RHMax.(TaЉ40к ).
2).The maximum wet bulb temperature 39 (TaЉк Ї 40 ) and wк ithout dewing.
3).If you use the product in a environment which over the definition of temperature and humidity too
long to effect the result of eye-etching.
4).Test Condition: IEC 1000-4-2 VESDt: Contact discharge to input connector; VESDC: Contact
discharge to module
www.panelook.com
VESDt -200 200 V
VESDc -8000 8000 V
к
к
*4)
*1). 2). 3). 5)
*1). 2). 3)
5).If you operate the product in normal temperature range, the center surface of panel should be under
60к .
6).Delay lighting testing needs the volt above start voltage Vrms. Before the procedure tube needs
typical lighting for 1 minute and stay in the temperature 25±2к for 24 hours and then testing in the
same condition in dark room.
Relative humidity(%RH
90
80
40,90
Operating Range
Storage Range
40
20
50.4
(60,27.7)
-20
0 20 40 60
Temperature (°C)
50
ʳ
CPT Confidential ʳ CHUNGHWA PICTUER TUBES, LTD. CLAB215FA01-PROVIEW -V1-20090209
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Page: 4/16
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
CPT CHUNGHWA PICTURES TUBES, LTD.,
3. OPTICAL CHARACTERISTICS
Ta=25к ΔVCC=5.0V
ITEM SYMBOL CONDITION MIN. TYP. MAX. UNIT REMARK
Contrast (CEN) CR 800 1000 -- -- *1)*2)
Center Transmittance T%
θ =Г0°
CPT BLU
4.09 4.64 % *1)*3)
Response Time Tr+Tf θ =Г0 -- 5 8 ms *4)
Horizontal 150 170 -- Deg.
CR 10Њ
View angle
Vertical
θ
140 160 -- Deg.
*5)
Horizontal 150 170 -- Deg.
CR 5Њ
Color
Coordinates
Vertical
Red
Green
Blue
θ
x
y
x
y
x
y
θ =Г0°
CPT BLU
150 170 -- Deg.
(0.622) (0.652) (0.682)
(0.303) (0.333) (0.363)
(0.259) (0.289) (0.319)
(0.577) (0.607) (0.637)
Base on
(Wx , Wy) =
(0.313 , 0.329)
(0.117) (0.147) (0.177)
(0.055) (0.085) (0.115)
[Note]
Color coordinate is measured by SRUL1R, response time is measured by TRD-100 and all the
other items are measured by BM-5A (TOPCON). All these items are measured under the dark room
condition (no ambient light).
Measurement Condition: IL=7.5 mA × 4
Inverter: Sumida, model: TWS-400-9656
Definition of these measurement items is as follows:
1) Setup of Measurement Equipment
The LCD module should be turn-on to a stable luminance level to be reached. The measurement
should be executed after lighting Backlight (CPT BLU) for 20 minutes and in a dark room.
2) Definition of Contrast Ratio
CR=ON (White) Luminance/OFF (Black) Luminance
ЁЁ
, Frequency=50kHz.
ʳ
CPT Confidential ʳ CHUNGHWA PICTUER TUBES, LTD. CLAB215FA01-PROVIEW -V1-20090209
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Page: 5/16
www.panelook.com