CLAA201VA02 is 20.1" color TFT-LCD (Thin Film Transistor Liquid Crystal Display)
module composed of LCD Panel, Driver ICs, Control Circuit Board, Backlight. By applying 8 bit
digital data, 640 ×480, 16.7M-color images are displayed on the 20.1" diagonal screen. Input power
voltage is 5.0V for LCD driving and interface of data and control signals is CMOS. General
specifications are summarized in the following table:
ITEM SPECIFICATION
Display Area(mm) 408.0(H) × 306.0(V) (20.1 inch diagonal)
Number of Pixels 640(H) × 480(V)
Pixel Pitch(mm) 0.6375(H) × 0.6375(V)
Color Pixel Arrangement RGB vertical strip
Display Mode Normally White, TN
Number of Colors 16.7M (8bits/color)
Brightness(cd/m^2) 500(cd/m2) @6.0mA
Response Time 16ms
Viewing Angle (-80~80)(H), (-65~70)(V)(Typ.)
Wide Viewing Angle Technology Super wide view film
Surface Treatment Hard coating:3H ; Anti-glare
Electrical Interface CMOS(VIN=3~5V, 1pixel/clock)
Total Module Power(W) 30W
Module Size(mm) 453.6(W) × 342.9(H) × 22.4(D)
Module Weight(g) 3410 (Typ.)
Backlight Unit 6 CCFLs side-lighting
The LCD Products listed on this document are not suitable for use of aerospace equipment,
submarine cables, nuclear reactor control system and life support systems. If customers intend to
use these LCD products for above application or not listed in "Standard" as follows, please contact
our sales people in advance.
Standard: Computer, Office equipment, Communication equipment, Test and Measurement
equipment, Machine tool, Industrial robot, Audio and Visual equipment, Other consumer
products.
2. ABSOLUTE MAXIMUM RATINGS
ITEM SYMBOL MIN. MAX. UNIT REMARK
Power Supply Voltage for LCD VCC -0.3 7.0 V
Logic Input Voltage
Voltage of Lamp VL - 2000 Vrms
Current of Lamp IL 0 8.0 mArms
Frequency of Lamp FL - 80 kHz
ESD(Static electricity)
ICC Rush Current IRUSH - 6 A Note2
Operation Temperature *1) Top 0 50
Storage Temperature *1) Tstg -20 60
[Note1] Test condition : Follow IEC 1000-4-2:
VESDt: for Input connector;VESDc:for Module
[Note2] 5μsec. If rise time of VDDD increases, then I
[Note3] Be without condensation while humidity ≦90% RH.
[Note4] Humidity
Relative Humidity ≦90% (Ta≦ 40℃) Wet Bulb Temperature ≦39℃(Ta≧40℃)
VDDD -0.3 6.0 V
VESDt -200 200 V
VESDc -8000 8000 V
℃
℃
decrease.
RUSH
Note1
Note3, 4
Note3, 4
3. ELECTRICAL CHARACTERISTICS
(a)TFT-LCD
CPT Confidential
2/16 CLAA201VA02-ver1-20040202
CPT CHUNGHWA PICTURES TUBES, LTD.,
4.5V
ITEM SYMBOLMIN TYP MAX UNIT REMARK
Power Supply Voltage for LCD VCC 4.5 5.0 5.5 V Note1
Power Supply Current for LCD ICC -- 240 450 mA Note2
Permissive Input Ripple Voltage VRP -- -- 100 mVp-p Vcc=12V
Logic Input Voltage
High
Low
VIH
VIL
2.5 3.3 5.5 V
0 -- 0.9 V
[Note 1]
1) VCC-turn-on conditions:
t1≦10ms 400ms≦t4
200ms<t2 200ms≦t5
0<t3≦50ms 0≦t6
0.9 VCC
LCD P owe r Supply
Logic Signal
0.1 VCC
VCC
0.9 VCC
data
0.1 VCC0.1 VCC
t2
t1
VL
Backlight Power Supply
t5t6
Data: RGB DATA, D CLK, HD, VD, DENA
t3
t4
2) VCC-dip conditions
When 3.6V≦VCC<4.5V, then td≦10 ms
VCC>4.5V
VCC-dip conditions should also follow the VCC-turn-on conditions.
3.6V
[Note 2] Typical current situation
256-gray-bar pattern, 480 line mode, VCC=5 V, fV=60 Hz, fH=31.5KHz, f
=25 MHz
CLK
CPT Confidential
3/16 CLAA201VA02-ver1-20040202
CPT CHUNGHWA PICTURES TUBES, LTD.,
pI-p
+
+
+
+
(b) Backlight
ITEM SYMBOL MIN TYP MAX UNIT REMARK
Lamp Voltage VL -- 785 -- Vrms IL=6.0mA
Lamp Current IL 5.5 6.0 6.5 mArms Note1,4
Lamp Frequency FL 45 50 70 kHz Note2,4
Starting Lamp
Voltage
Lamp life Time LT
VS
1530 -- -1280 -- --
40,000 50,000 --
Vrms
Vrms
hr
Ta=0℃
Ta=25℃
IL=6.0mA
Continuous
Operation
[Note1] Measurement Method of Lamp Current (the current meter is inserted in low voltage line)
LCD Module
CTL
CN2
CTL
CN3
CTL
CN6
CTL
CN7
-
CTH
-
|
|
|
CTH
A
A
Power
Supply
A
-
CTH
-
CTH
A
[Note2] The influence of lamp frequency
This frequency range can keep the electrical and optical character within 10%
variation. Lamp frequency may interfere with horizontal synchronous frequency (or vitical
synchronous frequency), and then cause ripple noise on the display. Therefore, please
adjust the frequency of lamp input, be removed inveter from module as possible, or use
electronic shielding between inverter and module to avoid the interference.
[Note3] Definination of the lamp life
The luminance reduced to 50% of initial value.
[Note4] Wave request
The degrees of unbalance: less than 10%
The ratio of wave height: less than √2 ±10%
The degrees of umbalance = Ip-I-p /Irms*100(%)
The ratio of wave height = Ip(or I-p)/Irms
I
Ip: high side peak
I-p: low side peak
CPT Confidential
4/16 CLAA201VA02-ver1-20040202
CPT CHUNGHWA PICTURES TUBES, LTD.,
4. INTERFACE PIN CONNECTION
(a) CN1(TFT-LCD signal)
Used connector: IL-FHR-F45S-HF-E3000 (JAE) or equivalent
Number Symbol Function
1 TEST Should be open during operation (Internal test only)
2 TEST Should be open during operation (Internal test only)
3 TEST Should be open during operation (Internal test only)
4 VCC 5V
5 VCC 5V
6 RO0 Red odd data (LSB)
7 RO1 Red odd data
8 RO2 Red odd data
9 RO3 Red odd data
10 GND GND
11 RO4 Red odd data
12 RO5 Red odd data
13 RO6 Red odd data
14 RO7 Red odd data (MSB)
15 GND GND
16 GO0 Green odd data (LSB)
17 GO1 Green odd data
18 GO2 Green odd data
19 GO3 Green odd data
20 GND GND
21 GO4 Green odd data
22 GO5 Green odd data
23 GO6 Green odd data
24 GO7 Green odd data (MSB)
25 GND GND
26 BO0 Blue odd data (LSB)
27 BO1 Blue odd data
28 BO2 Blue odd data
29 BO3 Blue odd data
30 GND GND
31 BO4 Blue odd data
32 BO5 Blue odd data
33 BO6 Blue odd data
34 BO7 Blue odd data (MSB)
35 GND GND
36 NC
37 GND GND
38 HD Horizontal sync
39 GND GND
40 VD Vertical sync
41 GND GND
42 DENA Data enable
43 GND GND
44 CLK Dot clock
45 GND GND
CPT Confidential
5/16 CLAA201VA02-ver1-20040202
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.