CLAA156WA01A is 15.6” color (16:9) TFT-LCD (Thin Film Transistor Liquid Crystal Display) module
composed of LCD panel, LVDS driver ICs, control circuit and backlight. By applying 6 bit digital data,
1366×RGB (3) ×768, 262K-color images are displayed on the 15.6” diagonal screen. general specifications are
summarized in the following table:
ITEM SPECIFICATION
Display Area (mm) 344.232 (H)x193.536 (V) (15.6-inch diagonal)
Number of Pixels 1366 ×3(H)×768 (V)
Pixel Pitch (mm) 0.252 (H)×0.252(V)
Color Pixel Arrangement RGB vertical stripe
Display Mode Normally white
Number of Colors 262,144(6bits)(LVDS)
Gamut 60%(typ)
Optimum Viewing Angle 6 o’clock
Response Time (ms) 8ms (Typ)
Surface Treatment Glare
Viewing Angle
Brightness (cd/m^2)
Uniformity
Consumption of Power (W)
Module Size (mm)
Module Weight (g) 520 (max)
40°、40° /15°、30°(Min.)
220 cd/m2 (5point)/6 mA (Typ.)
200 cd/m2 (5point)/6 mA (Min.)
5point:80%
13point:(65%)
6.35W(Max)
359.8(W)×210(H)×6.2(D)(Max)
The LCD Products listed on this document are not suitable for use of aerospace equipment, submarine cable,
and nuclear reactor control system and life support systems. If customers intend to use these LCD products
for applications listed above or those not included in the "Standard" list as follows, please contact our sales
in advance.
Standard:Computer, Office equipment, Communication equipment, Test and Measurement equipment,
Machine tool, Industrial robot, Audio and Visual equipment, Other consumer products.
CPT Confidential
CLAA156WA01A
CPT CHUNGHWA PICTURES TUBES, LTD.,
2. ABSOLUTE MAXIMUM RATINGS
The following are maximum value, which if exceeded, may cause faulty operation or damage to the unit.
Power Supply Voltage for LCD VCC 0 4.0 V
Operation Temperature Top 0 50
Storage Temperature Tstg -25 65
Delayed Discharge Time TD -- 1 sec *7)
【Note】
ITEM SYMBOL MIN. MAX.
Lamp voltage VL 700 920 Vrms
Lamp current IL 2 6.5 mArms *1). 2)
Lamp frequency FL 40 80 kHz
*1) Product life-time relate to lamp current, please operate production follow statement at page 9
〝(b)back light〞.
*2) When lamp current over the definition of absolute max, product life-time will decay rapidly or
operate unusual.
*3) The relative temperature and humidity range are as below sketch, 90%RH Max. (Ta40)≦ ℃
*4) The maximum wet bulb temperature 39(Ta≦ ℃>40) and without dewing.℃
*5) If product in environment which over the definition of the relative temperature and humidity out of
range too long, it will affect visual of LCD.
*6) If you operate LCD in normal temperature range, the center surface of panel should be under 60.℃
*7) Delay discharge time test condition :Starting lamp voltage=1650Vrms. (please follow statement at
UNIT
℃
℃
REMARK
*3). 4). 5). 6)
*3). 4). 5)
page 9 〝 (b) back light〞
Before test TD, lamp should operate at least 1min, and lamp current should follow typical lamp current
specification. To place panel at room temp. ( 25±2)below for 24hrs,nd then to measure TD with the same ℃
starting lamp voltage in dark room.
CPT Confidential
CLAA156WA01A
CPT CHUNGHWA PICTURES TUBES, LTD.,
DIFFRENTIAL INPUT VOLTAGE
3. ELECTRICAL CHARACTERISTICS
(A) TFT LCD
TEM
LCD POWER VOLTAGE VCC 3.0 3.3 3.6 V
LCD POWER CURRENT ICC - 400 500 mA
Rush CRRENT Irush - - 2 A
INPUT VOLTAGE
LOGIC
INPUT
VOLTAGE
(LVDS:
IN+,IN-)
COMMON
VOLTAGE
DIFFRENTIAL
INPUT VOLTAGE
THRESHOLD
VOLTAGE (HIGH)
THRESHOLD
VOLTAGE (LOW)
SYMBOL MIN TYP MAX UNIT REMARK
【Note 1】
【Note 2】
【Note 4】
VIN 0 - VCC V
VCM 1.125 1.25 1.375 V
︱VID︱
VTH - - 100 mV
VTL -100 - - mV
250 350 450 mV
【Note 3】
【Note 3】
【Note 3】
【Note 3】
When VCM = +1.2V
TOLERANCE
COMMON VOLTAGE
TOLERANCE
【Note 1】Power Sequence:
0.5 ms ≦t110ms ≦ 1 sect≦ 4
0.01 ms<t250 ms 200 ms≦≦t5
0.01 ms<t350 ms 200 ms≦≦t6
△VID - - 35 mV --
△VCM
- - 35 mV --
CPT Confidential
CLAA156WA01A
CPT CHUNGHWA PICTURES TUBES, LTD.,
td
Vin=3.3V
VCC-dip state
(1)when 3.0>VCC2.7V≧,td10 ms≦
(2)when VCC<2.7V,VCC-dip condition should as the VCC-turn-off condition.
2.7V
3.0V
【Note 2】Typical value is 0~63 gray level.(Horizontal line Pattern)
768 line mode,VCC= +3.3V