The AR-SG-4SM-W is a stylish push-button wall plate that
provides control of an An-10 system. Functions include.
Lights On / Off
Raise / Lower Light Levels
Scene Selection
Scene Programming
User programming mode for quick and easy scene
setting via infrared, RF (radio) or USB connection to
a PC running CP’s ALC programming software.
Compact design allows installation into standard UK and
European backboxes.
Fascia also available in other finishes.
Front features
Off button
Scene buttons
Overview
RF scene plate
AR-SG-4SM-W
Product Guide
Features
Scene buttons
Four buttons that offer 4 lighting scenes.
Raise and lower function
Use either buttons 1 and 2 to raise the light level.
Use either buttons 3 and 4 to lower the light level.
Off button
Toggle between lights off and last selected Scene.
IR receiver
Receives control and programming commands from an
IR (infrared) handset.
LEDs
The LEDs flash to indicate the that a valid setting has been
received via IR and are also used in the programming of
scenes.
LED ring
IR mode Fast flashing
RF mode Slow flashing
USB mode Continuous
USB port
Under the facia is a micro USB socket for use for
programming via a PC. See page 11 for details.
Optional 12Vdc supply terminal
To power the unit from an external supply, connect the
supply to this terminal ensuring correct polarity. Refer to
Technical Data on page 10 for power supply specification.
Back features
Optional
12Vdc
Supply
Terminal
LED ring
Fascia
2
Installation
BS4662 square back box
DIN standard round back box
Backbox Compatibility Mounting
The AR-SG-4SM-W is designed to fit both UK and EU
style backboxes.
25mm
Do not over tighten
Use the extender if there is less than 25mm free space.
Note: put the wires through the extender before
connecting
Remove front cover by using a flathead screwdriver or similar to gently prise off
the cover.
Optional 12Vdc supply wiring diagram
+
-
USB connection
Micro USB socket
12VDC
When connected to micro USB port, the LED ring turns on to indicate connection.
Unit will initially be in deep sleep mode. This is to preserve the battery. To activate, press and hold the centre button for
more than 1 sec to bring unit out of deep sleep. It is indicated by the LED ring flashing.
Activation
3
Using the scene plate
Default Scene Levels
The system is factory-set to provide the following
scene levels:
Scene 1 – all circuits at 100%
Scene 2 – all circuits at 75%
Scene 3 – all circuits at 50%
Scene 4 – all circuits at 25%
To change scene levels see Programming Scenes
on page 6.
Turning Lights On and Off
Selecting a Scene
Adjusting Current Light Levels (Raise / Lower)
4
Using the scene plate
Programming Scenes
Loading...