CPC DRUMQUIK PRO System Installation Manual
WHY USE A DRUMQUIK® PRO?
Safety:
Performance:
Easy:
Minimize spills, fumes and environmental impact
High flow capacity
Intuitive locking ring design for
quick connection
Durability:
Built to withstand harsh
operating conditions
FDA Materials:
Suitable for transfer
of food products
Vapor Management:
Ported vent
allows control of fumes, blanket gas
connection or pressure dispensing
Economic:
Low cost for high
volume, single-trip containers
Recyclable Materials:
Allow easy disposal with containers
®
DRUMQUIK
PRO
Dispensing System for
Professional Chemical Management
SYSTEM INSTALLATION GUIDE
Liquid Port
Shipping Plug
Vent Port
Vent
Check
Valve
COLDER PRODUCTS COMPANY
1001 WESTGATE DRIVE
ST. PAUL, MINNESOTA 55114
U.S.A.
PHONE: +1 651-645-0091
FAX: +1 651-645-5404
TOLL FREE: 800-444-2474
info@cpcworldwide.com
cpcworldwide.com
Copyright © 2015 by Colder Products Company. All rights reserved. CPC, Colder Products Company, Colder Products and
Colder are registered trademarks with the US Patent & Trademark Office.
COLDER PRODUCTS COMPANY GMBH
OSTRING 19
D-63762 GROSSOSTHEIM
GERMANY
PHONE: +49- 6026-9973-0
FAX: +49-6026-9973-173
cpcgmbh@cpcworldwide.com
cpcworldwide.com
COLDER PRODUCTS COMPANY LIMITED
FLAT B, 29/ F, WEST GATE TOW ER,
7 WING HONG STR EET, CHEUNG SHA WAN
KOWLOON, HONG KONG
PHONE: +852-2987-5272
FAX : +852-2987-2509
asiapacific@cpcworldwide.com
cpcworldwide.com
INSTALL5002 01/10 BP/5M
Printed in the U.S.A.
Drum Insert
Locking Ring
Dip-tube
Chemical Dispensing Made Easy
Simple steps to install and use the DrumQuik
®
PRO
Coupler
Installation
The DrumQuik® PRO drum insert
assembly replaces one of the
drum’s bung plugs and is torqued
and shipped as part of the drum
package.
Dispensing
Remove the shipping plug from
the drum insert assembly, then
connect the DrumQuik PRO
coupler, locking it into place.
1.
Fully press dip-tube into drum insert socket.
2.
Place the drum insert assembly in drum.
3.
Torque insert with drum wrench or 1/2" drive
torque wrench and a CPC torque socket tool
(CPC PN 2408900).
Note: Contact CPC for torque recommendations.
Vapor Management
Three vapor management options:
1. Fully open to vent vapors to the
atmosphere.
2. Connect CPC check valve (e.g. 2879800)
to allow make-up air in, without allowing
fumes to escape.
3. Connect a CPC quick disconnect coupling
for blanket gas (N
dispensing.
, CO2) or for pressure
2
1.
Turn shipping plug counterclockwise to remove.
(Use a large flat blade, #4 Phillips screwdriver
or coin.)
1.
Vent port fully open.
2.
Insert coupler into drum insert assembly.
2.
Vent port outfitted with CPC check valve.
3.
Turn the coupler locking ring clockwise until stop
is reached (approximately 2 full turns); valve is
opened during this process.
3.
Vent port shown with CPC quick disconnect
coupling.
Loading...