Coyote C1CSBNG Instructions

C1CSB LP/NG INSTALLATION GUIDE

STEP 1

• Remove the right side shelf from the cart

• The side shelf is supported by 4 screws - accessible from the bottom side

STEP 2

• Install 4 new bolts as well as the grommet provided (see picture 1) but do not tighten

the bolts yet as the new side burner will rest on them in STEP 4

(picture 1)

STEP 3

• Remove the C1CSB control knobs

• Remove the front panel by removing the 2 screws on the top and 2 screws at the

bottom (see pictures 2 & 3)

(picture 2)

(picture 3)

C1CSB LP/NG Installation Guide

STEP 4

• Install the side burner body on the cart by hooking and latching the burner onto the

cart’s screws installed in STEP 2 (see picture 4)

(picture 4)

STEP 5

• Tighten the bolts that hold the C1CSB onto the cart

o Screws are accessible on the back at locations A and B (see picture 5) and

locations C and D on the front (see picture 6)

(picture 5) (picture 6)

STEP 6

• Reinstall the C1CSB control panel by reattaching the 2 upper screws and 2 lower

bolts shown on step 3

C1CSB LP/NG Installation Guide