Page 1
C1CSB LP/NG INSTALLATION GUIDE
STEP 1
• Remove the right side shelf from the cart
• The side shelf is supported by 4 screws - accessible from the bottom side
STEP 2
• Install 4 new bolts as well as the grommet provided (see picture 1) but do not tighten
the bolts yet as the new side burner will rest on them in STEP 4
(picture 1)
STEP 3
• Remove the C1CSB control knobs
• Remove the front panel by removing the 2 screws on the top and 2 screws at the
bottom (see pictures 2 & 3)
(picture 2)
(picture 3)
C1CSB LP/NG Installation Guide
Page 2
STEP 4
• Install the side burner body on the cart by hooking and latching the burner onto the
cart’s screws installed in STEP 2 (see picture 4)
(picture 4)
STEP 5
• Tighten the bolts that hold the C1CSB onto the cart
o Screws are accessible on the back at locations A and B (see picture 5) and
locations C and D on the front (see picture 6)
(picture 5) (picture 6)
STEP 6
• Reinstall the C1CSB control panel by reattaching the 2 upper screws and 2 lower
bolts shown on step 3
C1CSB LP/NG Installation Guide
Page 3
STEP 7
• Install the new piping assembly (shown in picture 7) for the C1CSB and grill
consisting of:
o (1) 1/2” nipple x 3/8” nipple
o (2) 1/2” tee
o (3) 1/2” nipple x 3/8” nipple
o (4) 1/2” nipple x 3/8” nipple
(picture 7)
FINISHING THE INSTALL:
• Pressure test all fittings with soapy water to ensure that no LP or NG gas leaks are
present
• Finish by closing off and re-installing all panels on the back side of the C1CSB and
the grill unit
• Your C1CSB is ready for use
*** Note: This is just an installation guide. For any further details regarding the
proper hook-up of a gas supply, please refer to your owners manual for the grill and
side burner itself
C1CSB LP/NG Installation Guide
Loading...