I N S P I R I N G T H E W O R L D ’ S K I T C H E N
30” GAS COOKTOP
COS-850SLTX-E
INSTALL, USE, CARE GUIDE &
INSTALLATION INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
Carefully read the following Important information redarding installation
safety and maintenance. Keep these instruction for future reference.
COS-850SLTX-E USER MANUAL
THANK YOU FOR YOUR PURCHASE.
IMPORTANT SAFETY INSTRUCTIONS
BEFORE YOU BEGIN:
Please Read all instructions completely and carefully.
Thank you for your purchase. We know that you have many brands and
products to choose from and we are honored to know that you have decided
to take one of our products into your home and hope that you enjoy it.
COSMO appliances are designed according to the strictest safety and performance
standard for the North American market. We follow the most advanced
manufacturing philosophy. Each appliance leaves the factory after thorough
quality inspection and testing. Our distributors and our service partners are
ready to answer any questions you may have regarding how to install, use and
care for your products. We hope that this manual will help you learn to use the
product in the safest and most effective manner .
If you have any questions or concerns, please contact the dealer from whom you
purchased it, or contact our Customer Support at:
1-888-784-3108.
The manual also includes directions for the professional installer that will
install the product in your home. We recommend using trained personnel
for professional installation.
Please keep this manual for future use.
THANK YOU
CAUTION
IMPORTANT: Save these instructions
for local inspector’s use.
IMPORTANT : Observe all governing
codes and ordinances
Note to Installer : Be sure to leave
these instructions with the Consumer
Note to Consumer: Keep these instructions for future reference.
IMPORTANT: Check the leakage according to the installation instruction.
Product failure due to improper
installation is not covered under the
Warranty
WARNING
Disconnect all electrical power at the
main circuit breaker or fuse box before
installing. Installation of this cooktop
must conform with local codes or, in the
absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA54–
Latest Edition ANSI Z223.1/NFPA
• Be sure your cooktop is installed
properly by a qualified installer or
service technician.
• To eliminate reaching over surface
burners, cabinet storage above
burner should be avoided
• Do not install the unit near an
outside door or where a draft
may affect its use.
WARNING
FOR YOUR SAFETY:
If the information in this manual is not
followed exactly, a fire, explosion or
gas leak may result, causing property
damage, personal injury or death.
DANGER
Do not store or use gasoline or
other flammable vapors and liquids
in the vicinity of this or any other
appliance.
CAUTION
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
Do not touch any electrical switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
• Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
2 3
WARNING
• A statement that the installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas Code, ANSI Z233.1/NFPA 54.
TABLE OF CONTENTS
• A statement that the installation of appliances designed for manufactured
(mobile) home installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280 [formerly the Federal
Standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280)]
or with local codes where applicable.
• If an external electrical source is utilized, a statement that the appliance, when
installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code. ANSI/NFPA 70.
• A statement that:
(a) The appliance and its individual shutoff valve must be disconnected from
the gas supply piping system during any pressure testing of that system at test
pressures in excess of 1/2 psi (3.5kpa).
(b) The appliance must be isolated from the gas supply piping system by
closing its individual manual shutoff valve during any pressure testing
of the gas supply piping system at test pressures equal to or less than 1/2 psi
(3.5kPa).
• A statement of the maximum gas supply pressure in accordance with the inlet
pressure rating of the gas appliance pressure regulator supplied.
• A description of proper vent installation, if applicable, and the specific type
of gas vent to be used, including a statement that the vent pipe must be
mechanically fastened to the flue collar and instructions for accomplishing
this attachment.
INSTALLATION PREPARATION 6
ELECTRICAL REQUIREMENTS 7
INSTALLATION OPTIONS 8
DIMENSIONS AND CLEARANCE 9
POWER SUPPLY LOCATIONS 11
INSTALLATION INSTRUCTIONS 12
ASSEMBLE BURNERS, CHECK IGNITION 13
ADJUST BURNER FLAMES 15
CARE AND CLEANING 16
WARRANTY AND SERVICE 18
• The cooktop, as shipped from the factory, is set for use with its intended gas. If
you wish to use your cooktop with the alternate gas, you must first replace the
orifices and convert the pressure
regulator.
• This conversion must be performed by a qualified installer or gas supplier in
accordance with the manufacturer’s instructions and all codes and requirements
of the authority having jurisdiction. Failure to follow instructions could result in
serious injury or property damage. The qualified agency performing this work
assumes responsibility for the conversion.
4 5
INSTALLATION PREPARATION
IN THE COMMONWEALTH OF MASSACHUSETTS:
1. When preparing cooktop opening, make sure the inside of the cabinet
and the cooktop do not interfere with each other. (See section on preparing the opening.)
2. Slide the cooktop out of the end of the box. Remove packaging mate-
rials, grate boxes, regulator and 5 literature package from the cooktop
before beginning installation. Use the shipping carton as a pad to protect customer countertops or flooring
3. Remove Installation Instructions from literature package and read them
carefully before you begin. Be sure to place all literature, Owner’s Manual, Installations, etc. in a safe place for future reference.
4. Make sure you have all the tools and materials you need before starting
the installation of the cooktop.
5. Your home must provide the adequate electrical service needed to safely
and properlyyou’re your cooktop. (Refer to section on electrical requirements.)
6. When installing your cooktop in your home, make sure all local codes
and ordinances are followed exactly as stated.
7. Make sure the wall coverings, countertop and cabinets around the cook-
top can withstand heat (up to 200°F) generated by the cooktop.
PARTS INCLUDED:
9X
1X
·This product must be installed by a licensed plumber or gas fitter.
·When using ball-type gas shut-off valves, they shall be the T-handle type.
·A flexible gas connector, when used, must not exceed 3 feet.
Be sure the installation of this product in a mobile home conforms with the
Manufactured Home Construction and Safety Standard, Title 24 CFR, Part
3280. If this standard does not apply, you must follow the standard for Manufactured Home Installations, ANSI A225.1 and Manufactured Home Installations, Sites and Communities, ANSI/NFPA 501A or with local codes. You can
get a copy of the Federal Standard by Writing: Office of Mobile Home Standards HUD Building 451 7th Street, S.W. Washington, D.C. 24010.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the proper voltage and frequency and
connected to an individual, properly grounded branch circuit, protected by a
circuit breaker or fuse having amperage as noted on the rating plate.
We recommend you have the electrical wiring and hookup of your cooktop
connected by a qualified electrician. After installation, have the electrician
show you where your main cooktop disconnect is located.
Check with your local utilities for electrical codes which apply in your area.
Failure to wire your cooktop according to governing codes could result in a
hazardous condition. If there are no codes, your cooktop must be wired and
fused to meet the requirements of the National Electrical Code, ANSI/NFPA
No. 70— Latest Edition. You can get a copy by writing: National Fire Protection Association Battery march Park Quincy, MA 02269 In Canada, your
cooktop must be wired and fused to meet the requirements of the Canadian
Electrical
Code.
1X 1X
4X
MATERIALS YOU MAY NEED:
- Joint Sealant Pipe Fittings Shut-Off Valve,
- CSA-Approved Flexible Gas Line
Flexible
Connector
Note: Purchase new line, do not use previously used flexible gas line.
6 7
Convert LP Gas to Natural Gas Operation
If sold outside the U.S. and Canada:
If you wish to use this product with Liquefied Petroleum (LP) gas containing
greater than 10% butane, you must purchase the conversion kit #850SLTX-
ELP. To order, please call 1-888-784-3108
Loading...