SYDNEY
1/2 Windsor Road
Northmead NSW 2152
Ph: 02 9890 9111 Fax: 02 9890 4888
BRISBANE
626 Boundary Road
Coopers Plains QLD 4108
Ph: 07 3274 4222 Fax: 07 3275 2455
MELBOURNE
1 Fowler Road
Dandenong VIC 3175
Ph: 03 9212 4422 Fax: 03 9212 4433
PERTH
22 Brennan Way
Belmont WA 6104
Ph: 08 9373 9999 Fax: 08 9373 9977
www.machineryhouse.com.au
“setting the standard for quality and value”
1/2 Windsor Road Northmead NSW 2152
Ph: 02 9890 9111 Fax: 02 9890 4888
“setting the standard for quality and value”
1/2 Windsor Road Northmead NSW 2152
Ph: 02 9890 9111 Fax: 02 9890 4888
TROUBLE SHOOTING/POTENTIAL PROBLEMS
crooked cut
Material is at maximum capacity of machine1.
Feed pressure too high2.
Guides loose3.
Blade tension too low4.
Guides too far apart5.
Machine out of alignment6.
Teeth too ne for application7.
Uneven hardness in material8.
blade stalling
Guides too tight1.
Blade tension too low2.
Feed pressure too high3.
Speed too slow4.
Drive wheel surface contaminated with chips5.
Insufcient machine power6.
stripping teeth
Speed too slow1.
Incorrect TPI selection2.
Excessive feed pressure3.
Wire brush not working4.
Improper blade break in5.
Movement of material in vise during cutting6.
Hard skin on surface of material or uneven 7.
hardness within material
Insufcient coolant8.
premature teeth wear
Wrong selection of welded high speed edge1.
Speed too high2.
Improper blade break in3.
Feed pressure too heavy or too light4.
Extremely hard or abrasive material5.
Hard scale on surface of material or uneven 6.
hardness within material
Improper or insufcient coolant7.
premature blade breakage
Guides damaged or worn1.
Blade tension too high2.
Band wheels misaligned or shoulders worn3.
Guides too far apart or improperly adjusted4.
Feed pressure too high5.
Too short a span between wheels and guide 6.
arms
blade vibration or squeal
Blade speed1.
Guide tension2.
Spacing of guide arms3.
Blade tension4.
Feed pressure too low5.
Position of material in vise6.
Flow or mixture of coolant7.
Loading...