Thank you for purchasing the CONF410 Conference Telephone. Your new
Conference telephone is designed for small/medium conference rooms.
CONF410 Features:
Conference Call
On/Off Button with LED
Flash Button
Mute Button with LED
Redial Button
Volume Up/Down Buttons
Pulse/Tone Button
Pulse/Tone Switch
Ringer Hi/Lo/Off Switch
Optional External Microphone
Full Duplex
We want you to know all about your new Conference Telephone, how to install
it, the features it provides, and the services you can expect from its use.
PLEASE READ BEFORE INSTALLING AND
USING YOUR NEW CONFERENCE TELEPHONE
TABLE OF CONTENTS
Important Safety Instructions ......................................................................... 1
Always follow basic safety precautions when using your telephone equipment to
reduce the risk of fire, electrical shock, and injury.
1.Read and understand all instructions in the Owner’s Instruction Manual.
Read all warnings and follow all instructions marked on the product.
2.Unplug this product from the wall outlet before cleaning. Use a damp cloth
for cleaning. Do not use liquid or aerosol cleaners.
3.Do not use the telephone near water. For example, do not use near a bathtub,
wash bowl, kitchen sink, laundry tub, swimming pool, or in a wet basement.
4.Do not place this product on an unstable cart or stand. The product may fall
causing serious damage to the product.
5.Use only the type power source indicated on the label. If you are not sure of
the type power supply to your home, consult your dealer or local power
company.
6.Do not place any objects on the telephone line cord. Do not locate the
telephone where the line cord will be walked on.
7.Do not block or cover ventilation slots and openings in the bottom of the
telephone. The openings should never be blocked by placing the telephone on
a bed, sofa, rug, or other similar surfaces. The telephone should never be placed
near or over a radiator or heat register. The telephone should never be placed in
a built-in installation unless proper ventilation is provided.
8.Never spill liquid on the telephone or push objects of any kind throughventilation slots. Liquid or objects may touch dangerous voltage points or short
out parts that could result in a risk of fire or electrical shock.
1
9.Do not disassemble this product. Opening or removing covers may expose you
to dangerous voltages or other risks. Incorrect reassembly can cause electrical
shock when the product is subsequently used.
10.Do not overload outlets and extension cords. Some telephones require AC
power from an outlet. Overloading the outlets can result in the risk of fire or
electric shock.
11.Avoid using a telephone during a local thunderstorm. There may be a remote
risk of electrical shock from lightning.
12.Do not use a telephone to report a gas leak in the vicinity of the leak.
13.Unplug the telephone from the wall outlet and refer servicing to qualifiedservice personnel under the following conditions:
•When the line cord is frayed or plugs damaged.
•If liquid has been spilled into the telephone.
•If the telephone has been exposed to rain or water.
•If the telephone does not operate properly by following the operating
instructions. (Adjust only those controls covered by the operating
instructions. Improper adjustment of other controls may result in
damage and will often require extensive work by a qualified
technician to restore the product to normal operation.)
•If the telephone has been dropped or the housing damaged.
•If the telephone exhibits distinct change in performance.
SAVE THESE INSTRUCTIONS
2
INSTALLATION
Checklist of Parts
• Conference Unit
• AC Adapter
• Telephone Line Cord
• User’s Guide
• Optional External Microphone and Microphone Line Cord
To Ensure Best Performance
√ Locate the unit in a quite environment, with soft furnishings, such as
sound absorbing walls and ceilings.
√ Place the unit at the center of a table or desk.
√ Keep papers and other objects away from the unit.
√ Seat all participants no more than 3 meters from the unit or 2 meters
from the optional extension microphone.
√ Do not place on carpet or other similar surfaces.
√ Speak at normal conversation levels.
√ Make sure that the unit is at least 1 meter away from other electrical
products to avoid interference.
√ Direct your voice toward the microphone.
√ Do not move the unit during a call.
√ Avoid noisy environmental background during conversations.
Note: If any of the parts are missing,
please contact your dealer.
Setting Up
1. Connect the telephone line cord into the telephone jack on the conference
telephone and into the telephone jack on the wall.
2. Plug the AC power adapter into the power jack of the conference telephone
and nearby electrical outlet. (A beep will be heard from the conference telephone when the AC adapter is plugged in.)
3
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.