CHAIR
1 of 7
CAUTION: You must read this before you proceed
CAUTION : This Chair is NOT a TOY.
Keep your child / children at bay in the process of assembly.
For turning the Chair and to prevent damage to the Chair, 02 persons may be needed
to execute this action
No. Picture Description Qty
2 of 7
A Backrest Panel 1
B1
B2
C Seat Panel 1
D Cross bar 2
Right Leg Frame
Left Leg Frame
1
1
No. Picture Description Qty
①
②
③
④
Allen Key 1
Short Screw
5
(M6*35mm)
Medium Screw
3
(M6*60mm)
Long Screw
5
(M6*80mm)
Before Beginning Assembly:
3 of 7
OVERVIEW
Backrest
Panel (A)
Left Leg Frame
(B2)
This Chair has multiple parts and may require up to some 30 minutes to assemble. To
give you an overview of the Chair, the above picture to assemble to help you put the
various parts into perspective. Please read through the instructions here below to
familiarise the parts and steps before assembly.
Right Leg Frame
(B1)
Seat Panel(C)
Cross bar(D)
FRONT FACING
Step 1
4 of 7
Unpack and place all parts on a clean, non-marring surface.
Step 2
2.1) Position Backrest Panel (A) and 2 Cross Bar (D) to Left Leg Panel (B2) as shown
in picture above
2.2) Attach Right Leg Panel (B1) to 2 Cross Bars (D) by using 2 Screw(④)+Allen
Key(①)
Then, secure Right Leg Panel (B1) to Backrest Panel (A) by using Screw (③)+Allen
Key (①)
Do not fully tighten the Screws.
Step 3
(C)
5 of 7
With assistance from your adult partners, turn the Chair into the other side.
Repeat the same process of step 2.2 to secure Left Leg Panel (B2) with Backrest
Panel (A) and 2 Cross Bars (D)
Do not fully tighten the Screws.
Step 4
Seat Panel
Turn the chair in right side up
Place Seat Panel (C) onto the chair as shown above.
Step 5
Lay down the Chair one side and Secure Seat Panel (C) with Left Panel (B2) and
Right Panel (B1) by using 4 Screws (②) + Allen Key(①)
Do not fully tighten the Screws.
Step 6
6 of 7
If wobble
Test again
30-50cm
Place the Chair right side up on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Chair 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Chair freely and vertically with all four legs, hitting the ground at the same
time.
This Drop Test will help to ensure that all the Bolts, Screws and gaps reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Bolts, Screws.
When tightening the Bolts, Screws, tighten sequentially.
Do not tighten any Bolt, Screws fully and then move towards the next one.
This could cause the frame to warp.
If there are still wobbles, loosen the Bolts, Screws and execute the same drop
tests.
If the Chair is not stable it could lead to damage to the product.
Inspect the Chair and make sure all parts are connected.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
7 of 7
Loading...