
Label Picture Description QTY
A Backrest 1
B Left Arm Panel 1
Caution: You must read this before you proceed

Label Picture Description QTY

Before
Beginning
Assembly:
This Sofa has multiple parts and may require up to 15 minutes to
assemble. To give you an overview of the Sofa parts, the above picture is
to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.

Place the Backrest(A) faceup onto a clean, non-marring surface.
Attach Seater(D) to Backrest(A) using JCBC Bolts(④) and Washers(⑤)
with Allen Key(③).
Do not fully tighten the Bolts.
Unpack and place all parts on clean, non-marring surface.

Attach Backrest(A) to Right Arm Panel(C) and Left Arm Panel(B) using
JCBC Bolts(④) with Allen Key(③).
Do not fully tighten the Bolts.
Insert Wood Dowels(①) into the Seater Rail(E) as pictured above.
Attach Seater Rail(E) to Right Arm Panel(C) and Left Arm Panel(B) using
JCBC Bolts(④) and Barrel Nuts(②) with Allen Key(③).
Do not fully tighten the Bolts.

Turn the Sofa right side up.
Place the Sofa on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the Sofa.
This would help to align all the parts at all the joint areas.
Then get off the Sofa, and in a sequential manner, proceed to tighten all
Bolts.
When tightening these Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then towards the next one.
This could cause the frame to warp.
If there is still wobbles, loosen the Bolts and execute this same
process.
Your Sofa is ready to be used.
This Sofa can only be used on a flat, level surface.