Page 1
ASSEMBLY INSTRUCTIONS
N
L
4
Please read carefully and save these instructions, as you may need them
later. CAUTION!
Turn off the main power at circuit breaker before installing the fixture, in order
to prevent possible shock. All glass is fragile, use care when handling . The
important safeguards and instructions appearing in this manual are not meant
to cover all possible conditions and situations that may occur. It must be
understood that common sense, caution, and care are factors which cannot be
built into any product.
These factors must be applied by the person(s) caring for and operating the
fixture.
Power connection to be made by qualified personnel in accordance with
the National Electrical Code. Please connect power according to the table
below.
Fixture Conductor Marking Connect to AC Power Conductors
"L"Live Conductor [Black or Brown] "L" Line Voltage Conductor[Black]
"N"Neutral Conductor [White or Blue] "N"Neutral Conductor [White]
" "Ground Conductor [ Green or Bare] " "Ground Conductor [Green or Bare]
D
C
E
F
G
H
A
B
Installation instructions:
Step 1.Install the arms (A) on the lamp body and
tighten the screws(B) with a small wrench (included) .
Step 2.Pass the cord through the pole(G),Install the
pole(G) on the screw (H) .
Step 3.Install the other side of pole(G) on the
canopy (E) .
Step 4.Twist the brass ground wire" " with the M4
green threaded screw on the mounting bracket and
lock it to the GND position .Then twist the two
ground wires together (one is the brass ground
wire" ", the other is the ground wire from the
junction box ,and tighten it by the terminal nut.
Step 5.Black wire from junction box attaches to "L"
wire for the fixture by terminal nut ;white wire
attaches to "N" wire by terminal nut.
Step 6.Use the two screws(D) secure mounting
bracket(C) to the junction box.
Step 7.Use the screw nut(F) secure canopy(E) to the
mounting bracket(C).
Step 8.Install the bulbs(I)( not included).
Loading...