Page 1
WARNING:
We suggest a qualified, licensed electrician to perform the installation.
Before star ting installation disconnect the power by turning off the Circuit Breaker
or by removing fuse at the fuse box.
Outlet Box
Install Mounting Plate:
1. isconnect power at the circuit breaker.
2. Pull the Supply Wires from the Outlet Box.
3.Attach the Mounting Bracket to the Outlet
Box using the Bracket Mounting Screws.
4. Hand tighten to secure.
Bracket
Mounting Screw
Install Arms:
1. Screw each pre-wired arm into center hub turning clockwise until it sits flush and fixed .
2. Repeat this step for each arm until they are secure.
Grou nd Wire
Cano py
Hexa gonal Nut
Supply Wires
Mounting Plate
Flat/Slope
Ceiling Available
Adap ter
Adju stable Rods
10.0 inch (2 55 mm)
Adjustab le R ods
Arm
1. Use allen wrench to unscrew the small black or brass finish screw and insert the tube in.
2. Screw each pre-wired arm into center hub turning clockwise until it sits flush and fixed.
Use allen wrench to tighten the tube with small black or brass finish screw turning clockwise
until it sits flush.
3. Repeat second and third step to install the other tubes until they are secure.
Page 1
Page 2
Install Fixture to the Mounting Plate:
1. Position canopy over the mounting plate.
2.
3. Insert the Bulbs (MAXIMUM WATTAGE 60W).
Please Note: DO NOT EXCEED THE WATTAGE AS STATED ON THE WARNING LABEL.
4. After the bulbs have been installed, restore the electricity and check the
operation of your new fixture.
Dimmer Note: For the best lighting experience, we recommend using a dimmer.
Not only does this allow you to create a great ambiance, it allows for energy
savings and extends the life of the bulbs.
2
Loading...