Page 1
Ceiling Light Installation
To our clients: Thank you for buying our product, please read this instruction book carefully before you start installing the ceiling light.
1.Please read the instruction book carefully before you start installing and maintaining the ceiling light, and keep it properly after you read it in case you need this to instruct in the
future. Please ask a real professional to install the light to keep the good quality of the ceiling light and your safe.
2. The electric power should be limited in a range (rated voltage is AC110V, and 10% higher or lower than that is not allowed, the frequency should be 60 Hz.) If the voltage that the
ceiling light use excess the rated voltage in a long period, it may damage the ceiling light because the ceiling light may get heat.
3. Please check whether the cable and the plug is still in a good condition before you use the light, and make sure that the local voltage can match the rated voltage of the light.
4. Please cut off the electric power before you install the ceiling light.
5. Please do not install the ceiling light in any area with high temperature, such as a place near the stove, the gas or the exhaust funnel, and avoid getting moisture.
6. If the light isn’t on after power on, please check if the light is in a good condition, and check if it is caused by a loose connection in the wires.
7. Please clean and check the light at regularly intervals. When you clean the light, the electric power should be cut off at first. Please use a soft and dry cloth to wipe the surface of
the light, any acid or alkaline solvent will damage the surface of the light.
Step 1
Pass the wire through the threaded rod and out through the
threaded nut
Step 4
Step 2 Step 3
Nut
Star Washer
Bare Ground Wire
Canopy
Lamp Arm
Canopy
Lamp Arm
Canopy
All White wire are connected to the Neutral wire.
All Black wire are connected to the Fire wire.
Step 5 Step 6
Junction Box
Fixture Ground Screw
Lamp Arm
Universal Mounting
Bracket
Canopy Screw
(Tightened Finger
Tight)
Mounting Bracket
Screw
Fixture Bare
Ground Wire
Bare Ground
Wire
Junction Box
Brown to Fire Wire
Blue to Neutral Wire
Post-purchase: The installation process should be strictly followed by the installation instruction.
In use: If you found the light flash frequently or don’t work, please use the standby light bulb to change the old one or contact the seller.
— Notice: Do not repeatedly turning the light on and off —
Page 2
Bare Ground Wire
Canopy
Canopy Nut
Nut
Lamp Arm
Canopy
Threaded Rod
Ground Wire
Rod
Rod cover
Lampshade
Lamp Arm
Nut
Threaded Nut
Nut
Lamp Arm
Canopy Nut
Lamp Arm
Canopy Cover
Loading...