Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose any small parts necessary for
installation.
2. By measuring, determine correct distance hole in mounting plate, then drilled
three holes(by measuring distance hole) in the ceiling at junction box of side;
raise the plastic anchor insert the hole. Attach the mounting plate to the
junction box with two junction box screws and three wood screws as shown,
tighten screws securely with the screwdriver. The side of the mounting plate
marked "GND" must face out. The junction box is not included.
3. Raise the end cord of shade(C), through the canopy’s cone shape coupling,
by measuring, determine correct cord length of needed for proper hanging
height, then lock it securely with the small screw. NOTE: SLIDE WIRE CLIP
TO THE PROPER POSITION, THEN YOU MAY PROPERLY CUT THE
CORD IS TOO LONG PARTS. CONNECT THE ELECTRICAL WIRES AS
SHOWN IN FIG.2.
4. While holding the lamp body towards the ceiling, connect the electrical wires
as Shown in Fig.2, making sure that all wire nuts are secured. You may have
to wrap the connections with electrical tape. If your outlet has a ground wire
(green or bare copper), connect the fixture ground wire to it. Otherwise
connect fixture’s ground wire directly to the Mounting plate with the green
screw provided. This lamp body provided two copper ground wires, one
copper ground wire connects cord’s ground wire, other one copper ground
wire connects outlet’s ground wire or mounting plate’s green screw. After
wires are connected, tuck them carefully inside the Junction Box.
5. Raise the lamp body(A) onto the junction box, aligning the pipe thread on
mounting plate with mounting hole in canopy and lock it securely with the
round nut(B).
6. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAG!
Your installation is now complete. Return power to the junction box
the fixture.
46593
FIG.1
Fig.2
FIXTURE
WIRES
Lettering
( L )
Or Black
FIXTURE
Cordclip
WIRES
NO Lettering
( N )
B
C
Or White
FIXTURE
WIRES
Yellow
Thread
(Ground)
( )
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us on-line at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20191146593
HOUSE
WIRES
Black
(Hot)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Copper(Ground)
Bare
Loading...