Page 1
Before you throw the carton, please ensure that
you have all the parts needed for the assembly.
1.For each step please don’t fully tighten all the screws
at first, when they all align to the holes you can fully
tighten them.
Spare parts can be found in the hardware
box if you do not have enough bolts for assembly.
4pcs
4pcs
( )foot caps
2pcs
Page 2
D
Please check to make sure you have all parts and hardware before
starting assembly process.
Seat 4pcs Legs 16pcs Connecting Tube 4pcs
E
F
Connecting Circle 4pcs Bolts 16pcs Wrench 1pc
2
Page 3
Remove the bolts from the connecting tube and legs.
(total 16pcs)
Use the bolts remove from the tube to connect legs and
connecting rub. Screw the bolts by hand about 3 turns.
F
up
per di
abo ut 20
Please make sure you know the difference between the
upper and lower side of connecting circle when you asse
-ble it to legs.
stanc
i
n
lo
we
ab
out 18
e is
r dis
t
an
.5i n
c
D
e i
upper si
low
e
r s
s
id
e
de
D
Connect the leg to seat use the bolts remove from legs. Turn the
4:
bolts by hand about 3 turns.
3
Page 4
Put seat on a soft and flat place(see diagram 1). Connect assembled
5:
legs to the swivel on the bottom of seat. Screw the bolts by hand about
3 turns, Put pre-assembled chair on a flat place(see diagram 2) and
adjust four legs foot caps until the chair is steady,
the short side of wrench.
tighten all bolts by
F
E
diagram 1
diagram 2
4
Loading...