Page 1
CLUB CHAIR
Pleas look in the Seat Frame for hardware packs
CAUTION: This Chair is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever lifting the Chair and to prevent damage to the Chair two adults are
needed to execute this action.
1 OF 7
Page 2
Parts List
No.
A
B
Picture Description
Back Right Leg
Front Right Leg
Qty
1
1
D
E
C
Front Left Leg
Back Left Leg
Seat Frame
1
1
1
F
Seat Cushion
1
2 OF 7
Page 3
Hardware
Chair Hardware
No.
Picture Description
1
2
3
4
Assembly Preparation
Before Beginning Assembly:
Bolt M6 x 40mm
Bolt M6 x 60mm
Washer
(6/16 x 2mm)
Allen Key
Qty
9
5
13
1
x 9
Read instructions, cover to cover.
Have 2 adults on hand for assembly.
x 11
x 13
Do not assemble on flooring or carpet.
Assemble on a clean non-marring surface (packing foam).
Save all packaging until finished.
3 OF 7
Page 4
Assembly Steps
OVERVIEW
Back Left Leg (D)
Seat Frame (E)
Seat Cushion (F)
Back Right Leg (A)
Front Left Leg (C)
Front Right Leg (B)
FRONT FACING
This Chair has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Chair parts, the above picture is to help you put the
various parts into perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
4 OF 7
Page 5
Assembly Steps
Step 2
D
2
A
E
3
4
3
1
4
Place the Seat Frame (E) facedown on a clean, non-marring surface as shown in
above picture. Attach the Back Right Leg (A) and Back Left Leg (D) to the Seat
Frame (E) by using Screw (1), Screws (2) ,Washers (3) and Allen Key (4).
Do not fully tighten the Screws.
Step 3
C
3
D
B
2
4
3
1
E
4
3
A
1
4
Attach the Front Right Leg (B) and Front Left Leg (C) to the Seat Frame (E) using
Screws (1), Screws (2), Washer (3) and Allen Key (4).
Do not fully tighten the Screws.
5 OF 7
Page 6
Assembly Steps
Step 4
With the assistance from your adult partner, turn the Chair right side up.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Legs and Chair reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten Bolts in a sequential manner, until evenly
secured.
When tightening Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen Bolts and excute the same above process.
Step 5
F
Put Seat Cushion (F) onto the Chair.
Tie the velcro straps of Seat Cushion(F) to the slats of Seat Frame (E).
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
6 OF 7
Page 7
7 OF 7
Loading...