Corrigan Studio W002379713 Installation & Assembly

Page 1
Assembly Instructions
Caution: You must read this before you proceed
Loveseat
Caution: This Loveseat is NOT a TOY. Keep your child/children at bay during the assembly process. Whenever moving/lifting the Bench II and to prevent damage to the Loveseat, two adults are required to execute these actions.
Page 2
Label Picture
Description Qty
C
Seat Panel 1
D
Backrest Panel 1
E
Right Leg Panel
1
F
Left Leg Panel
1
G
Support Bar
1
H
Seat Cushion
1
I
Back Cushion
1
No.
Picture Description
Qty
Screw (M7x80mm)
5
Screw (M7x60mm)
3
Allen Key
2
Hardware
Part List
Page 3
Assembly Preparation
Before Beginning Assembly:
Assembly Steps
Overview
Seat Cushion(H)
Support Bar(G)
Left Leg Panel (F)
Back Cushion (I)
FRONT FACING
Backrest Panel (D)
Seat Panel (C)
Right Leg Panel (E)
Page 4
This Bench II has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Loveseat parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
F
G
D
Step 2.1
Step 2.2
Page 5
Step 3
Insert Seat Panel (C) into assembled on step 2 as shown in picture above.
2.1 With the help of your adult parner,insert tenons of Left Leg Panel (F) intothe mortises of Backrest Panel (D) and Support Bar (G) as shown above.
2.2 ASecure the Left Leg Panel (F) to Backrest Panel (D) and Support Bar (G) using Screw (,) with Allen Key () as shown in picture above. Repeat the same process of Right Leg Panel (E )
Do not fully tighten the Screws.
C
Page 6
Step 4
Place Seat Cushion(H) and Back Cushion(I) onto the Bench II, turn the Bench II down and tie the velcro straps of the Back Cushion (H) to the Backrest Panel (D) as shown above
I
H
Page 7
Step 4
Then EXERT pressure, floorwards onto the Loveseat with both hands. This pressure will help the Loveseat reach full alignment at all joints. In a sequential manner, gradually tighten alScews at all joints until evenly secured. Inspect the Loveseat and make sure all parts are adequately connected.
Your Loveseat is ready for use. This Loveseat can only be used on a flat, level surface.
Page 8
Loading...