Corrigan Studio W002379713 Installation & Assembly

Assembly Instructions

Caution: You must read this before you proceed

Chair

Caution: This Chair is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Chair and to prevent damage to the Chair, two
adults are required to execute these actions.

1 of 7

Label

Picture Description

Qty

A

Seat Panel

1

B

Backrest Panel 1

C

Right Leg Panel

1

D

Left Leg Panel 1

E

Support Bar

1

F

Seat Cushion

1

G

Back Cushion

1

No. Picture Description Qty

①

Screw (M7x80mm)

5

②

Screw (M7x60mm)

3

③

Allen Key 2

Hardware

Part List

2 of 7

This Chair has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Chair parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.

Overview

Assembly Preparation

Before Beginning Assembly:

Assembly Steps

Seat Cushion(F)

Support Bar (E)

Left Leg Panel (D)

Back Cushion (G)

FRONT FACING

Backrest Panel (B)

Seat Panel (A)

Right Leg Panel (C)

3 of 7

Step 1

Unpack and place all parts on a clean, non-marring surface.

With the help of your adult parner, insert tenons of Backrest Panel (B) and Support
Bar (E) into the mortises of Left Leg Panel (D) using Screw (①,②) with Allen
Key(③) as shown in picture above.
Repeat the same process with Right Leg Panel (C )

Do not fully tighten the Screws

B

E

②

③

D

①

③

4 of 7

Step 3

Insert Seat Panel (A) into the assemble on step 2 as shown in picture above.

Step 4

Place Seat Cushion(F) onto the Chair, turn the Chair down and tie the velcro straps of
the Seat Cushion (F) Seat Panel (A ) as shown above
Turn the Chair right side up, place the Back Cushion (G) into the Chair, tie the velcro
straps of Back Cushion(G) to the Backrest Panel (B) as shown above

A

G

F

5 of 7

Step 5

Then EXERT pressure, floorwards onto the Chair with both hands.
This pressure will help the Chair reach full alignment at all joints.
In a sequential manner, gradually tighten alScews at all joints until evenly secured.
Inspect the Chair and make sure all parts are adequately connected.

Your Chair is ready for use.

This Chair can only be used on a flat, level surface.

6 of 7

7 of 7