Page 1
Label Picture Description QTY
A Backrest 1
B Seat 1
C Chair Legs 1
D Seat Cushion 1
E Back cushion 1
Assembly Instructions
Caution: You must read this before you proceed
Chair
Picture
Part List
Page 1 OF 5
Page 2
Label Picture Description QTY
①
Bolt
(M6X20mm)
5
②
Bolt
(M6X30mm)
5
③ Allen Key 1
④ Washer 9
⑤ Spring Washer 9
⑥ Cap 9
Assembly Preparation
Before
Beginning
Assembly:
×5
×5
×9
×9
×9
Hardware
Page 2 OF 5
Page 3
Step 2
Place the Seat(B) face up onto a clean, non-marring surface.
Align the Seat(B) to Backrest(A) as shown above.
Attach Seat(B) to Backrest(A) using Bolts(②), Spring Washers(⑤) and Washers(④) with Allen Key(③).
Do not fully tighten the Bolts.
Assembly Steps
Overview
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the the
Chair parts, the above picture is to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
FRONT FACING
Backrest (A)
Chair Legs (C)
Seat Cushion (D)
Seat (B)
Back cushion (E)
Page 3 OF 5
Page 4
Step 5
Cover the Bolts(①) and Bolts(②) using Caps(⑥).
Step 3
Place the Seat(B) facedown.
Align the Seat(B) to Chair Legs(C) as shown above.
Attach Seat(B) to Chair Legs(C) using Bolts(①), Spring Washers(⑤) and Washers(④) with Allen Key(③).
Note: The front Legs are high and the back low.
Do not fully tighten the Bolts.
Step 4
Stand the Chair up.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Legs and Seat reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
Page 4 OF 5
Page 5
Step 6
Stand the Chair up.
Put the Seat Cushion(D) onto the Chair.
Secure the Seat Cushion using the Velco straps as pictured.
Step 7
Place the Back Cushion(E) on the Chair.
Your Chair is ready for use.
This Chair can only be used on a flat and level surface.
Page 5 OF 5
Loading...