Page 1
Assembly Instructions
Caution: You must read this before you proceed
DINING CHAIR
Page 1 OF 6
Page 2
Part List
Before
X9
X5
Label Picture Description QTY
A Seat 1
B Wood Leg 4
Hardware
Label Picture Description QTY
①
②
③
④
⑤
Assembly Preparation
Beginning
Assembly:
Bolt(M6*25mm) 9
Flat Washer 9
Allen Key 1
Base Angle 5
Spring Washer 9
X9
X9
Page 2 OF 6
Page 3
Step 1
Assembly Steps
OVERVIEW
Wood Leg(B)
Seat(A)
FRONT FACING
This Dining Chair has multiple parts and may require up to 30 minutes
to assemble. To give you an overview of the Dining Chair parts, the
above picture is to help you put the various parts into perspective.
Please read through the instruct i ons below to familiar i se yourself with
the parts and steps before assembl y.
Open the carton and place all parts on a cl ean, non-marring surface.
Page 3 OF 6
Page 4
Step 2
Step 3
Wood Leg(B)
①
⑤
②
Wood Leg(B)
③
Seat(A)
Place the Seat(A) face down, on a clean, non-marr i ng surface.
Insert the Wood Leg(B) into Seat(A), align mounting positions
between the Wood Leg(B) and Seat(A), then attach the Wood Leg(B)
to Seat(A) using Bolt (①) ,Spring Washer(⑤),Flat Washer(②) with
Allen Key ( ③) .
Repeat the same step to instal l the remaining three Legs(B).
Do not fully tighten the Bolt.
Base Angle(④)
Page 4 OF 6
Page 5
Step 4
Install the base Angel(④) to the wooden leg(B) with hand as pictured
above.
Place the Dining Chair on a LEVEL SURFACE.
Inspect it and make sure all part s are adequately connected. Gently
and
gracefully, sit into to the Dining chair.
This will help to align all the parts at all joint areas.
Then get off the Dining Chair and proceed t o tighten the Bolts(①) in a
sequential manner.
When tightening the Bolts(①) tighten sequenti al ly.
DO NOT tighten any Bolts(①) fully and then move on towards the next
one.
If there are still wobbles, loosen the Bolts(①) and execute this same
process.
Your Dining Chair is ready for use.
This Dining Chair can only be used on a flat, level surface.
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...