Assembly Instructions
Caution: You must read this before you proceed
DINING CHAIR
Page 1 OF 6
Before
Part List
X9
X9
Label Picture Description QTY
A Seat 1
B Wood Leg 4
Hardware
Label Picture Description QTY
①
②
③
④
⑤
Bolt(M6*25mm) 9
Flat Washer 9
Allen Key 1
Base Angle 5
Spring Washer 9
Assembly Preparation
Beginning
Assembly:
X9
X5
Page 2 OF 6
Step 1
Assembly Steps
OVERVIEW
Wood Leg(B)
Seat (A)
FRONT FACING
This Dining Chair has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Dining Chair parts, the above
picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and
steps before assembly.
Open the carton and place all parts on a clean, non-marring surface.
Page 3 OF 6
Step 2
Step 3
Seat(A)
①
Wood Leg(B)
⑤
①
③
③
⑤
②
②
Place the Seat(A) face down, on a clean, non-marring surface. Insert
Wood Leg(B) into Seat(A), align mounting positions between the Wood
Leg(B) and Seat(A), then attach using Bolt(①),Spring Washer(⑤) and
Flat Washer(②) with Allen Key(③).
Repeat the same step to install the remaining three Legs(B)
Do not fully tighten the Bolt.
Base Angle(④)
Page 4 OF 6
Step 4
Install the Base Angel(④) to the wooden leg(B) with hand as pictured
above.
Place the Dining Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected. Gently and
gracefully, sit into to the Dining chair.
This will help to align all the parts at all joint areas.
Then get off the Dining Chair and proceed to tighten the Bolts(①) in a
sequential manner.
When tightening the Bolts(①) tighten sequentially.
DO NOT tighten any Bolts(①) fully and then move on towards the next
one.
If there are still wobbles, loosen the Bolts(①) and execute this same
process.
Your Dining chair is ready for use.
This Dining chair can only be used on a flat, level surface.
Page 5 OF 6
Page 6 OF 6
Loading...