The products, technical information, and instructions contained in this manual are subject to change without notice.
These instructions are not intended to cover all details or variations of the equipment, nor to provide for every possible contingency in the installation, operation or maintenance of
son(s) working on the equipment have been trained and are skilled in w
and mechanical equipment. It is assumed that appropriate safety precautions are taken and that all local safety and
construction requirements are being met, in addition to the information contained in this manual.
This Product is warranted only as provided in
ject to all of the restrictions and limitations contained in the Commercial Warranty.
Cornelius’ Commercial Warrant applicable to this Product and is sub-
this equipment. This manual assumes that the per-
orking with electrical, plumbing, pneumatic,
Cornelius will not be responsible for any repair, replacement or
from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal
service conditions with respect to the Product, (2) improper voltage, (3) inadequate wiring, (4) abuse, (5) accident,
(6) alteration, (7) misuse, (8) neglect, (9) unauthorized repair or the failure to utilize suitably qualified and trained persons to perform service and/or repair of the Product, (10) improper cleaning, (11) failure to follow installation, operating, cleaning or maintenance instructions, (12) use of
compatible with the Product) which use voids the entire warranty, (13) Product parts in contact with water or the
product dispensed which are adversely impacted by changes in liquid scale or chemical composition.
other service required by or loss or damage resulting
“non-authorized” parts (i.e., parts that are not 100%
Contact Information:
To inquire about current revisions of this and other documentation or for assistance with any Cornelius product contact:
www.cornelius.com
800-238-3600
Trademarks and Copyrights:
This document contains proprietary information and it may not be reproduced in any way without permission from
Cornelius.
This document contains the original instructions for the unit described.
UC 701 Series Continuous Flow Icemaker Installation and Service Manual
!
DANGER:
!
WARNING:
CAUTION:
!
!
WARNING:
!
SAFETY INSTRUCTIONS
READAND FOLLOW ALL SAFETY INSTRUCTIONS
Safety Overview
• Read and follow ALL SAFETY INSTRUCTIONS in this manual and any warning/caution labels on the unit (decals, labels or
laminated cards).
• Read
Recognition
and understand ALL applicable OSHA (Occupational Safety and Health Administration) safety regulations before
operating this unit.
Recognize Safety Alerts
This is the safety alert symbol. When you see it in this manual or on the unit,
be alert to the potential of personal injury or damage to the unit.
DIFFERENT TYPESOF ALERTS
Indicates an immediate hazardous situation which if not avoided WILL result in serious injury, death or equipment
damage.
Indicates a potentially hazardous situation which, if not avoided, COULD result in serious injury, death, or equipment
damage.
Indicates a potentially hazardous situation which, if not avoided, MAY result in minor or moderate injury or equipment
damage.
SAFETY TIPS
• Carefully read and follow all safety messages in this manual and safety signs on the unit.
eep safety signs in good condition and replace missing or damaged items.
• K
arn how to operate the unit and how to use the controls properly.
• Le
• Do not let
infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance.
eep your unit in proper working condition and do not allow unauthorized modifications to the unit.
• K
anyone operate the unit without proper training. This appliance is not intended for use by very young children or
QUALIFIED SERVICE PERSONNEL
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit. ALL WIRING
AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL CODES. FAILURE TO COMPLY COULD
RESULT IN SERIOUS INJURY, DEATH OR EQUIPMENT DAMAGE.
UC 701 Series Continuous Flow Icemaker Installation and Service Manual
!
WARNING:
CAUTION:
!
CAUTION:
!
!
WARNING:
SAFETY PRECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued protection
observe the following:
Disconnect power to the unit before servicing following all lock out/tag out procedures established by the user. Verify
all of the power is off to the unit before any work is performed.
Failure to disconnect the power could result in serious injury, death or equipment damage.
Always be sure to keep area around the unit clean and free of clutter. Failure to keep this area clean may result in
injury or equipment damage.
SHIPPING AND STORAGE
Before shipping, storing, or relocating the unit, the unit must be sanitized and all sanitizing solution must be drained
from the system. A freezing ambient environment will cause residual sanitizing solution or water remaining inside the
unit to freeze resulting in damage to internal components.
MOUNTINGINORONA COUNTER
When installing the unit in or on a counter top, the counter must be able to support a weight in excess of 205 lbs.to
insure adequate support for the unit. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH OR
EQUIPMENT DAMAGE.
NOTE: Many units incorporate the use of additional equipment such as icemakers. When any
addition equipment is used you must check with the equipment manufacturer to determine the
additional weight the counter will need to support to ensure a safe installation.
UC 701 Series Continuous Flow Icemaker Installation and Service Manual
GENERAL INFORMATION
TOTHE USEROFTHIS MANUAL
This manual covers the installation and assembly of the Air--Cooled or Water--Cooled Model UC 701 Icemaker with
the Model UC150 Dispenser. Refer to Table of Contents for page location of detailed information pertaining to
questions that may arise during installation or operation of this equipment.
DESCRIPTION
The UC701 is a chuncklet Icemaker designed to be installed under a counter adjacent to an Ice Dispenser or an Ice
Storage Bin. The Icemaker will deliver ice to either the left or right side. The Icemaker requires a 12--inch by 12-inch opening at the lower front of the Unit for air intake. A minimum of 1.5 sq. ft. opening must be provided out the
left or right side and the rear of the machine for air exaust.
CLAIMS INSTRUCTIONS
Claims: In the event of shortage, notify the carrier as well as IMI Cornelius immediately. In the event of damage,
notify the carrier. IMI Cornelius is not responsible for damage occurring in transit, but will gladly render assistance
necessary to pursue your claim. Merchandise must be inspected for concealed damage within 15 days of receipt.
WARRANTY REFERENCE INFORMATION
Warranty Registration Date
(to be filled out by customer)
Unit Part Number:
Serial Number:
Install Date:
Local Authorized Service Center:
DESIGN DATA
Table 1. Design Data
Unit Model Number:
UCR700--A Series Continuous--Flow Icemaker (Air--Cooled)
UCR700--W Series Continuous--Flow Ic
Unit Overall Dimensions:
Height27 inches
Width13.7 inches
Depth25.5 inches
Clearances Dimensions Required:
Front Side Service Access (Removable front panel to allow removal of Unit)
UC 701 Series Continuous Flow Icemaker Installation and Service Manual
Table 1. Design Data
(cont’d)
Unit Model Number:
Water Supply--Water inlet fitting is 1/4--inch SAE flare located at the top front of the Unit. The Unit is designed to operate on
water pressure between 10 PSI and 90 PSI.
Drain Overflow Line (Located at rear of the Unit)3/8--inch Flexible Tubing
Ambient Operating Temperature40° F to 100° F
Electrical:
Unit Electrical Rating208/230 VAC, 60 Hz,11.3 Amps,