CoreSWX MACH4 User guide

MACH4 Series

V-MT, B-MT, and G-MT

Battery Charging System

Quad

Instructional Manual

Introduction:

Thank you for your choice in purchasing a Core SWX MACH4 Charger. The charger is designed to
provide you a safe and reliable charging platform for your battery packs.

Please read this manual to help understand and capitalize on the features of this

charger.

Features:

• This charger will rapid charge any Li-ion battery pack within CoreSWX’ product line.

• Automatic Universal AC input for world-wide use.

• Automatic detection of damaged or misused batteries

• Cross-compatible battery charging for RED®, Anton/Bauer®, IDX® and most Li-Ion battery packs*

*contact Core SWX for confirmation of battery pack compatibility.

Operation:

• Insert included AC power cord to the rear of the unit and flip adjacent switch to ON(-)

• LEDs will illuminate GREEN signifying the corresponding battery charging bay is READY

• Connect

independently and simultaneously, so it doesn’t matter which bay a battery pack is connected to.

• Corresponding bay LED will illuminate RED, advising communicating with the charger, and will

being charging the pack.

a battery pack to any of the charge positions. The charger addresses all packs

LED Indication Guide:

Charge State LED

No Battery Connected GREEN

Trickle Charge Pulse RED/GREEN*

Charging Complete GREEN

Charge Bay Malfunction LED not illuminated

*Trickle charge may occur when the battery pack is in low voltage protection or at/near 100%

LED Indication

Specifications:

MACH4 (Quad Charger):

Dimensions: H: 4.25” L: 12.17”
Weight: 5.3lbs.

W: 9.25”

Electrical Data:

Input Voltage: 90~240VAC, 50/60Hz
Quick Charge Current: 3.0A per channel
Discharge Current: 2.0A
DC output: 90w, 16VDC

Operational Temperature Range:

-0°C to +40°C (-32°F to +104°F)

Notes on Use:

• WARNING! Risk of electric shock. Do not remove cover, no user serviceable parts inside the
product. Disassembling the product may void the warranty.

• WARNING! Risk of electric shock. Always check cables for signs of damage. Damaged cables
can cause personal injury and/or damage the equipment.

• While operating the charger do not place any objects in front of ventilation slots or fan on the rear
of the charger.

• WARNING! It is the responsibility of the local organization to ensure that the product i
periodically checked for electrical safety in accordance with local regulations.

s

• WARNING! An increase in temperature is normal during operation. During discharge operation,

the area on the top of the charger, to the rear may get very hot. This is marked by a warning. Be
mindful of touching this area during operation.

• CAUTION! This product must be connected to a power supply of the same voltage (V) and
current (A) as indicated on the product. Refer to the technical specifications for the product.

• CAUTION! AC Mains plug or appliance coupler is to be used as a power disconnect device;
make sure it is readily accessible.

• CAUTION! The product must be grounded during operation

There is a fuse within the AC receptacle which can be replaced only with the same type and rating.

Warranty:

This product is warranted to the Original Purchaser against all defects in material and or workmanship
for the period herein.

The warranty period shall be, 3 years for parts and labor, unless otherwise noted. Core SWX agrees to
pay equal return freight costs to return the product the same method it was received. In the event of an
issue, purchaser agrees to the below RMA procedure.

Procedure:

1. Go to http://www.coreswx.com/repairsreturns and fill out the online form

2. Print the RMA number confirmation, and ship the product needing service to Core SWX, LLC.
along with RMA number confirmation, and copy of bill of sale.

3. All shipments must be done either through UPS or FEDEX, and insured if necessary

4. Core SWX, LLC. is not responsible for any lost shipments.

Core SWX reserves the right to repair or replace any defective product under warranty after Core SWX
determines which is more practical.

If Core SWX receives defective product for warranty repair and they are found to be defective as a result
of misuse or other damage, not caused by normal wear and tear, Core SWX will notify the customer of an
estimate of repair. Customer will incur costs. There are no further warranties, either expressed or implied,
including warranties of merchantability or fitness for a particular purpose that has any bearing upon this
transaction.

91B Commercial St. Plainview NY 11803 USA

Web: www.coreswx.com Email: [e-mail]

Tel: [phone] Fax: [phone]

Copyright © 2022

All rights reserved

Disclaimer

The information contained in this manual is believed to be correct at the time of issuance. Core SWX, LLC. reserves the right to
make the changes to the information or specifications without obligation to notify any person of such revisions or changes. Changes
will be incorporated in new versions of the manual.

Core SWX, LLC. reserves the right to make changes to product design and functionality without notification.

Trademarks

All product trademarks and registered trademarks are the property of Core SWX, LLC. All other trademarks and registered
trademarks are the property of the respective companies.