Corematic Automatic Core Saw Operating Instructions Manual

1

All new Corematic Core Saws carry the following guarantees;

Five years on Frames, Covers and Side Panels.

Five years on Motors.

Two years on Drives.

One Year on Wear Parts i.e. Chain and Wear Strips.

Corematic offers Delivery, Installation, Commissioning and Training of

personal with certificates anywhere in South Africa and Africa. Pricing

Dependent on location.

30 Arnold street, Alrode Telephone: [phone]
P.O. Box 1370 Facsimile: [phone]
Alberton, 1450 E-mail: [e-mail]
South Africa

OPERATING INSTRUCTIONS FOR

COREMATIC AUTOMATIC CORE SAW

Form 27 Rev 02 01/06/2016

2

Loosen & Remove

Replace & Tighten

INSTALLATION

1. Loosen and remove the three screws as indicated in FIGURE 1 from the back end of the saw.

2. Line up the Core Tray with the three wholes and secure it with the screws removed in Step 1.

(FIGURE 2.) and (FIGURE 3.).

3. Connect Hosepipe to the Saw. (FIGURE 4.)

4. Connect the Drainage Hose supplied with the Saw to the Water Gulley. (FIGURE 5.)

5. Connect the machine to the Mains (380 - 415 Volts, Three Phase).

PLEASE NOTE:
IF THE MACHINE IS RUNNING FROM A GENERATOR, PLEASE INSURE THE
GENERATOR HAS AN AUTOMATIC VOLTAGE REGULATOR FITTED AND IS

WORKING PROPERLY, AS WARRANTY CONDITIONS WILL BECOME VOID IF NO

A.V.R IS USED.

FIGURE 1.

FIGURE 2.

Form 27 Rev 02 01/06/2016

3

Connect Hose

Saw’s Tap

Connect

Drainage

Hose Here

Water

Gulley

Core Tray is

FIGURE 3.

FIGURE 4.

FIGURE 5.

Form 27 Rev 02 01/06/2016