Focus Ring 135˚ Swivel Lens
LABELLINGINSTRUCTIONS FOR
SAFE USE
CorDE X Instr uments Lt d. 1 Owens R d, Middlesb rough, TS6 6HE, UK
TP241 0 – Explos ion Proof Digital Ca mera
Ex d IIB+H2 T6 GbTamb -20 °C to +50° C
ATEX –TRAC13ATEX0046X
IECEx :IECEx TRC 1 3.0016X
Serial Number- XXXX-XX-XXXX
Year of Construction- YYY Y
Powered by – Ref er to Manual
II 2 G
CE 051 8
DO NOT OP EN WHEN EX PLOSIVE ATMOSPHERE PRESEN T
As defined by clause 29.2( i) of EN6007 9-0
The con ditions r eferenced in this se ction
relat e specific ally to haz ardous area
applications and must be followed.
In accor dance wi th clause 5. 1 of EN 6007 9-1,
the critical dim ensions of t he flamepaths are:
• Contact the manufacturer for information on
the dimensions of the flameproof joints.
• The apparatus must only be used in areas
where there is low risk of impact.
• Do not charge battery pack in the hazardous
area.
• The battery must be removed from the
camera and charged in the CorDEX
Instruments ToughPIX II charging bay. Using
a different charging device can cause
damage and void certification.
• The ToughPIX II 2410 Series digital camera
incorporates a protected battery system
with a non-replaceable fuse. This fuse is
only to be replaced by CorDEX Instruments
or a CorDEX Instruments Approved Repair
Facility. Failure to do so will void the
certification.
• Ensure that the ToughPIX II 2410 Series
digital camera battery pack is secured
using the plug provided. If the plug is lost,
only replace with a plug of the correct size
and type. If in doubt, contact your nearest
CorDEX Instruments representative.
• The ToughPIX II 2410 Series digital camera
is manufactured from aluminium alloy; and
must contain less than 7% magnesium by
weight and incorporates toughened glass
windows. This should be taken into account
when considering the end use application.
• The ToughPIX II 2410 Series digital camera
cannot be maintained in the field and must
be returned to the manufacturer should
repair or maintenance be required.
• USB communications with the ToughPIX II
2410 Series digital camera must only occur
within the non-hazardous area.
• When replacing the battery pack, the screw
must be re-tightened to a torque of 1.5-4Nm
and the cover cap replaced.
• Only CorDEX battery pack CDX2400-011 shall
be used.
Flamepath Maximum
Gap (mm)
Minimum L
(mm)
Rear
carriage/front
carriage
0.04 6.5
Flash
Window/front
carriage
0.1 13.8
LCD Window/
front carriage
0.1 13.8
Lens window/
front carriage
0.1 13.8
Operating
rod/rear and
0.1 10.5