Cordes Haussicherheit CC-800 User guide
SOLAR POWER
VIBRATION/MAGNET ALARM
MODEL: CC-800
Product Diagram
A
Installation
ut the Jumper Cap into the back of the main unit firstly as showed in
P
icture B .
p
nstall the main unit on the bracket as showed in picture C.
I
pply the double sided adhesive tape (included) to the backside bracket
A
f the main unit and magnetic module. Mount to window, door or cabinet
o
pening, aligning main unit with the magnetic module, it can be on the left
o
r right hand side , the gap between main and magnetic module is less than
o
0mm.
1
INSTRUCTION MANUAL
OTE:
N
: ‘Remove the Jumper Cap will return to factory default code
A
: Do not set the new code start with 4 as 4 is the digit to arm the unit.
B
nd the former three digits cannot be set as ‘111’ or ‘222’as these
A
odes will be forbidden and turn to disarm mode
c
: For security reason, if this procedure is not completed correctly
C
ithin 30 seconds, alarm will return to disarm mode
w
ctivate/deactivate vibration function
A
nder disarm mode, input correct code, then input activate code ‘222’, red
U
ED will flash three times to confirm the vibration function is activated and
L
eturn to disarm mode.
r
nder disarm mode, input correct code, then input deactivate code ‘111’,
U
ed LED will flash three times to confirm vibration function is deactivated
r
nd return to disarm mode.
a
NOTE: The vibration detect function is activated automatically when install
the Jumper Cap.
peration
O
hen existing from the protected area
W
Press number ‘4’ on keypad and a confirmed tone will indicate that the
alarm is armed. You have 30 seconds to vacate the area. After this time,
if magnetic contact is broken or vibration is detected, the alarm will be
triggered.
B
C
Programming the alarm
Set PIN code
PIN code can be modified under disarm mode as below:
1. Open the back cover and install the Jumper Cap properly as
showed in picture A (6)
2. Input default code (default factory code ‘1234’), red LED flashes
3. Enter new four digits PIN code
4. Red LED light flashes three times to confirm new code is set
successfully, the unit will return to disarm mode
hen entering the protected area
W
Simply type your four digit security code (default factory code ‘1234’) within
5 seconds. This will disarm the alarm.
Please note: The Main unit has installed 1pc lithium battery which can
charge energy by the solar panel. (1).
LED (Low Battery Indicator) Status
If LED is flashing, it means the charging is saturated.
If LED keeps flashing discontinuously, it means changing the code
at present.
If LED is on, it is low battery indicator and means battery energy is low.
The battery is needed to be charged.
Care and maintenance
To clean the case, simply use a soft slightly damp cloth with water and wipe
dry immediately.
Caution: Never use chemicals to clean the case, as they may damage the
plastic and the function of product.
SPECIFICATION:
Measure main unit: 4,6cm x 4,6cm x 2,1cm
Measure magnetic contact: 1,3cm x 4,5cm x 1,2cm
W x H x T
Horn Level: 85db(A) 3m
Ambient Humidity: 10% - 90%
Weight incl. battery: 49g
Power Source: rechargeable batterie
(included)
Op de Solt 42 · D – 22391 Hamburg
Loading...