CORBY 3300, 4400, 7700, CLASSIC, DELUXE User guide
...
TROUSER PRESS
USER GUIDE
GUIDE DE L’UTILISATEUR
BENUTZERANLEITUNG
GUIA DEL USUARIO
GUIDA PER L’UTENTE
GEBRUIKSAANWŸZING
GEBRUIKSAANWIJZING
BRUGERVEJLEDNING
BRUKSANVISNING
BRUKSANVISNING
KÄYTTÖOPAS
УКООДСО О
КСЛУ
CORBY
3300
CORBY
4400
CORBY
7700
CORBY
CLASSIC/DELUXE
CORBY
STATESMAN
12
13
1
2
3
4 5
6
7
8
9
10
11
IMPORTANT SAFETY
INSTRUCTIONS
When using your appliance, basic precautions should always be
followed, including the following:
1. Read all the instructions.
2. Use the appliance only for its intended purpose.
3. To reduce the risk of electric shock, do not use appliance in a
bathroom, do not immerse the appliance in water or other liquids.
4. Never yank cord to disconnect from outlet: instead, grasp plug and
pull to disconnect.
5. Do not operate appliance with a damaged cord or if the appliance
has been dropped or damaged. Special purpose tools are required
to replace the cord. To reduce the risk of electric shock, do not
disassemble or attempt to repair the appliance. Take it to a
qualified service person for examination or repair. Incorrect
reassembly or repair could cause a risk of fire, electric shock, or
injury to persons when the appliance is used.
6. Close supervision is necessary for any appliance being used by or
near children, the elderly or infirm persons. Do not leave appliance
unattended while connected.
Item 7 applies to the U.S.A. and Canada only.
7. To reduce the risk of electric shock, this appliance has a polarised
plug (one blade is wider than the other). This plug will fit in a
polarised outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
8. If the appliance is fixed (wallmounted), it must be positioned so the
plug is accessible.
SAVE THESE INSTRUCTIONS
Corby have specialised in making trouser presses since the 1930s when the
company was founded in Windsor, England. Today Corby sell presses for
home and hotel use throughout the world. Although there have been many
technical changes since that time we have continued with the tradition of
producing high quality British products. Each press is hand assembled and
individually tested prior to despatch from our Andover factory.
Assembly Instructions
Please check the contents carefully and contact your supplier if any of the contents
are missing or damaged. For the safety of babies and young children please
dispose of all plastic bags.
Feet
CORBY 3300/4400/7700/CLASSIC (Diagrams 1 & 2)
For stability ensure that the LONGEST part of the foot is at the FRONT of the
press. Tilt the press to one side and slide the foot onto moulding. A sharp tap with
the hand will click the foot into place. Turn the press over and repeat the
procedure for the other foot. Stand the press upright.
CORBY CLASSIC DELUXE/STATESMAN
(Diagram 3)
Contents: 4 Bolts and 4 Washers
For stability ensure that the LONGEST part of the foot is at the FRONT of the
press. Lay the press on its side and using the bolts provided, bolt the foot to the
bottom of the press, making sure that the washer is between the head of the bolt
and the foot. Turn the press over and repeat the procedure for the other foot.
Stand the press upright.
Hanger
CORBY 3300/4400 (Diagrams 4 & 5)
Contents: 2 x Hanger Screws
Screw hanger bracket to back of the press matching the LOWEST hole in the
bracket to the LOWER hole in the back of the press. Insert the second screw into
the TOP hole. With the hole facing the rear, slide the hanger onto the bracket until
it clicks home.
Assembly Instructions
Loading...