Corbin Russwin CL3550, CL3570, CL3580, CL3581 Installation Instructions Manual

Installation Instructions

®

Grade 1 Key-In-Lever

Cylindrical Lockset

CL3500 Series

IMPORTANT: The accuracy of the door preparation is critical for the proper functioning and security of this lever

handle lock.Misalignment can cause premature wear and a lessening of security.

BHMA

CE RTI FIE D

In U.S.:

Corbin Russwin, Inc.

225 Episcopal Road

Berlin, CT 06037 USA

www.corbinrusswin.com

Technical Product Support: Phone: [phone]

In Canada:

ASSA ABLOY Door Security Solutions Canada

160 Four Valley Drive

Vaughan, Ontario, Canada L4K4T9

www.assaabloy.ca

ASSA ABLOY

Attention Installer

Please read these instructions carefully to prevent

missing important steps.

Please note:Improper installation may result in

damage to the lock and void the factory warranty.

Install Latchbolt

A

Install Lockbody

B

Install Inside Trim

C

4

1

3

5

2

6

B

A

C

mlw - 07/25/08

FM237 (07/12)

TEST OPERATION: Rotate levers to see that latchbolt moves freely.

DO NOTFORCE.

If lockset does not operate properly, remove lockset from door and check door preparation.

Copyright © 2012 Corbin Russwin Inc., an ASSA ABLOY Group company.

All rights reserved. Reproduction in whole or in part without the express written

Permission of Corbin Russwin, Inc. is prohibited.

1 of 4

Door & Frame Preparation

Mark door

Locate and mark horizontal center line at desired height above

floor. Fold template over edge of door, centering on horizontal

line.Mark centers of holes at proper backset.Mark both sides

of the door.

Note:

Be sure to verify backset before marking & drilling door.

Install Strike

®

ASSA ABLOY

Drill door

A.2-1/8” (54mm) hole thru door. Cut ANSI tab notch es

as shown on template (except CL3550 and CL3570).

B.Drill 1”(25mm) hole in edge of door.Cut out for

latch front 5/32” (4mm) deep. 1-1/8” (29mm) wide

x 2-1/4” (57mm) high.Check latch unit for proper

width front and square or round corners

(except CL3550 and CL3570).

C.Drill two (2) 11/32”(8mm) Dia. holes through door

for all functions.

Caution:

To avoid splintering wood doors,drill holes from both sides.

Optional Installations

For CL3580 & CL3581 Function Only.

Copyright © 2012 Corbin Russwin Inc., an ASSA ABLOY Group company.

2 of 4

All rights reserved. Reproduction in whole or in part without the express written

permission of Corbin Russwin, Inc. is prohibited.

FM237 (07/12)