Corbero FE1240S/0 User Manual

Page 1
REFRIGERADOR
FRIDGE
FE 1240 S/0
LIBRO DE INS TRUCCIONES
INS TRUCTION BOOKLET
2222 103-41
Page 2
WARNINGS
If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child.
This must be done before the appliance is built intoThese warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance.
General Safety
¥ This appliance is designed to be operated by
adults. Children should not be allowed to tamper with the controls or play with the product.
¥ It is dangerous to alter the specifications or
modify this product in any way.
¥ Before any cleaning or maintenance work is
carried out, be sure to switch off and unplug the appliance.
¥ This appliance is heavy. Care should be taken
when moving it
¥ ce lollies can cause frost burns if consumed
straight from the appliance.
Service/Repair
¥ Any electrical work required to install this
appliance should be carried out by a qualified electrician or competent person
¥ This product should be serviced by an authorized
Service Centre, and only genuine spare parts should be used.
¥ Under no circumstances should you attempt to
repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always
Use
¥ The domestic refrigerators and freezers are
designed to be used specifically for the storage of edible foodstuffs only.
¥ Best performance is obtained with ambient
temperature between +18¡C and +43¡C (class T); +18¡C and +38¡C (class ST); +16¡C and +32¡C (class N); +10¡C and +32¡C (class SN). The class of your appliance is shown on its rating plate.
Warning: when the ambient temperature is not included within the range indicated for the class of this appliance, the following instructions must be observed: when the ambient temperature drops below the minimum level, the storage
temperature in the freezer compartment cannot be guaranteed; therefore it is advisable to use the food stored as soon as possible.
¥ Frozen food must not be re-frozen once it has
been thawed out.
¥ ManufacturersÕ storage recommendations should
be strictly adhered to. Refer to relevant instructions.
¥ The inner lining of the appliance consists of
channels through which the refrigerant passes. If these should be punctured this would damage the appliance beyond repair and cause food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. See defrost instructions.
¥ Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance.
Installation
¥ There are working parts in this product which
heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions.
¥ Care must be taken to ensure that the appliance
does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly available from the manufacturer or its service agent.
¥ Parts which heat up should not be exposed.
Wherever possible the back of the product should be against a wall.
¥ If the appliance has been transported
horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor.
9
Page 3
10
CONTENTS
Warnings 9 Use 11
Cleaning the interior 11 Operation 11 Temperature regulation 11 Fresh food refrigeration 11 Movable shelves 11 Positioning the door shelves 11 Hints 12
Hints for refrigeration 12 Maintenance 12
Periodic cleaning 12 Periods of no operation 12 Interior light 12
Defrosting 12
Customer service and spare parts 13 Technical information 13 Installation 14
Location 14
Electrical connection 14 Rear spacers 15 Changing the opening direction of the door 15
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable.
Page 4
11
Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be placed at different heights.
To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
D040
Movable shelves
The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with luke­warm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these will damage the finish.
Operation
Insert the plug into the wall socket.
Open the refrigerator door and turn the thermostat knob, clockwise, beyond the ÇOÈ (STOP) position. The appliance will start to operate.
To stop operation, simply turn the thermostat knob to position ÇOÈ
Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on:
¥ room temperature;
Fresh food refrigeration
To obtain the best performance:
¥ do not store warm food or evaporating liquids in
the refrigerator;
¥ do cover or wrap the food, particularly if it has a
strong flavour.
¥ Position food so that air can circulate freely round
it.
USE
¥ how often the door is opened;
¥ the quantity of food stored;
¥ location of appliance.
A medium setting is generally the most suitable.
Important
If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
PR187
Page 5
MAINTENANCE
Unplug the appliance before carrying out any maintenance operation.
Periodic cleaning
Clean the inside with warm water and bicarbonate of soda.
Rinse and dry thoroughly.
Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption.
Periods of non-operation
When the appliance is not in use for long periods, take the following precautions:
remove the plug from the wall socket;
remove all food;
defrost and clean the interior and all accessories;
leave the door ajar to allow air to circulate to prevent unpleasant smells.
HINTS
Hints for refrigeration
Useful hints: Meat (all types): wrap in polythene bags and place
on the glass shelf above the vegetable drawer.
For safety, store in this way only one or two days at the most.
Cooked foods, cold dishes, etc..: these should be
covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly
cleaned and placed in the special drawer(s)
provided. Butter and cheese: these should be placed in
special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible.
Milk bottles: these should have a cap and should be stored in the bottle rack on the door.
Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator.
Interior light
The light bulb inside the refrigerator compartment can be reached as follows:
- unscrew the light cover securing screw.
- unhook the moving part as shown in the figure.
If the light does not come on when the door
is open, check that it is screwed into place properly. If it still does not light up, change the bulb.
The rating is shown on the light bulb cover.
Defrosting
Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.
It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water
D037
D411
12
Page 6
13
CUSTOMER SERVICE AND SPARE PARTS
If the appliance is not functioning properly, check that:
¥ the plug is firmly in the wall socket and the mains
power switch is on;
¥ there is an electricity supply (find out by plugging
in another appliance);
¥ the thermostat knob is in the correct position.
¥ If there are water drops on the bottom of the
cabinet, check that the defrost water drain opening is not obstructed (see ÒDefrostingÓ section).
¥ If your appliance is still not working properly after
making the above checks, contact the nearest service centre.
To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side.
overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole.
Important:
Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.
Do not use a maechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer.
Energy Efficiency class C
228
0,70
256
1240
540
570
Energy Consumption kWh/24h
Energy Consumption kWh/year
Net Fridge Capacity lt.
Dimensions mm
High
Width
Depth
TECHNICAL INFORMATION
The technical infomation are situated in the rating plate on the internal left side of the appliance .
Page 7
14
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a contact for this purpose.
If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician.
The Manufacturer declines all responsibility if the above safety precautions are not observed.
This appliance complies with the following E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent modifications.
INSTALLATION
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A). Ideally, however, the appliance should not be positioned below overhanging wall units (B). Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet.
100 mm10 mm
10 mm
A
B
NP006
Page 8
15
Rear spacers
The plastic bag containing all relevant documentation also contains two rear wall spacers to be fitted into special slots on the back of the appliance. Fit the spacers into the slots, taking care to ensure that the arrow (A) is positioned as shown in the figure. Next, turn them through 45¡ (arrow in vertical position) until they lock into place.
PR60
A
45°
G
180°
1 3
2
D299
2
PR220
Door reversal
Unplug the appliance before all operations.
To reverse the door, proceed as follows:
1. dismantle the lower hinge (3), pin (1) and the screw (2);
2. slide the door out from pin (G),unscrew the pin and reposition on the opposite side;
3. unscrew the left front foot and reposition on the opposite side;
4. unscrew the two screws which mask the holes for fixing the hinge from the left front side;
5. reassemble the door;
6. reassemble the lower hinge (turning it 180¡), the pin and the screw on the opposite side, as shown in the figure;
7. Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs supplied in the documentation pack.
Attention After completion of the door reversibility
operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.
Loading...