COP-USA W600-TVI 2XP, W600-TVI, W600HD-2STK Specsheet
HDTVI/CVI/AHD Balun
Model Number: W600TVI-2X
Product Description:
W600TVI-2X is a passive high definition balun with transmission distance of color signal up to 300m/984ft. It can be used as
both transmitter and receiver, suitable for the expansion and application of HDTVI/CVI/AHD video surveillance system,
such as office building, community, school and hospital, etc.
Product Feature:
◆ No need to provide power with screw terminals
◆ To send HDCVI, HD-TVI, AHD signal 720p at 300M/984ft, 1080p at 200M/656ft over UTP cable
◆ Support 720P (25 / 30FPS) and 1080P (25 / 30FPS)
◆ Built-in transient protection
Technical Parameters
Connectors BNC, screw terminals
Cable UTP Cat5 / Cat5E / Cat6
Impedance Unbalance 75Ω; Balance 100Ω
Format 720P, 1080P for for HDTVI, HDCVI and AHD
Signal to Noise Ratio ≥60dB
Temperature -25 ～ +70
Humidity 0 ～ ＜95% (Non-condensation)
Product Dimension:
Note: This connection is with screw terminals. Recommend the cable ＞0.18mm
2
(＜1mm2 ).
Product Connection Diagram:
Product Installation Instructions:
Step Installation Instruction
1 Connect the video signal to BNC terminal of Transmitter (1).
2 Connect UTP cable to the negative pole (2) of Transmitter.
3 Connect UTP cable to the positive pole (3) of Transmitter.
4 Connect UTP cable to the positive pole (4) of Receiver.
5 Connect UTP cable to the negative pole (5) of Receiver.
6 Connect the video signal of Receiver to display device (6).
Use Notes:
Cable Selection
1. Recommend to choose the standard cables to achieve the excellent image effect.
a. Single wire diameter should be above 0.5 mm.
b. Resistance of single wire with 100 meters shouldn’t exceed 10Ω.
c. Cable twist density should reach Cat5 standard.
d. Cable flame resistance and flexibility should reach national standard.
2. Suggest you use waterproof type cable to ensure the image effect and long time use in the outdoor environment.
3. For general project application, recommend to use the three pairs of one UTP cable to transmit three signals, letting
the remaining one pair lines reserve or for grounding operation.
Cable Connection
1. Twisted-pair cable can't be connected with strong voltage cables together and when connected to the strong current
equipment, keep the distance.
2. Cable connection can adopt connector, welding, twist ground, and should ensure that the connection is firm and
waterproof.
3. The cable length form camera to transmitter should be as short as possible, permitted within 20 meters.
Product Use
1. Please offer good waterproof since there is no waterproof design for product.
2. There is no difference for transmitter and receiver. They can be used reversely.
3. If devices fail, please do not disassemble or repair by yourself, please contact us timely.
Loading...