
Ⅰ.Summarize
Outdoor full weather housing, body of housing was made by aluminum. Surface was
disposed, which has corruptproof. Using the traver-tip, convenience for adjusting;inside
with fan、heater and wiper. Suitting for bad enviroment;with lens decoder,control
convenience. Structure is firmly, it is suit for outdoor.
Ⅱ.Technology Datas
1.Voltage:AC24V
2.Operating temperature:-5℃~45℃
3.Weight: 5.5Kg
Ⅲ.Main components and parameter
Input voltage AC24V
Heater ~24V(20W)
Fan
Temperature
control
Lens control
DC 12V(1.2W)
Over 45℃,fan startup
Low -5℃,heater startup
ZOOM/FOCUS/IRIS:±12V
Ⅳ.Measure
Ⅵ.Installation way
1.Loosening two stainless steel hexagon screws (M4) of back-lid.
2.Installing camera and lens on bottom board, adjusting to proper position.

3.According Figure 1 to connect camera’s control wire and power supply. Note:please
secern camera’s power supply DC12V or AC24V. If power supply is DC12V,could get
DC12V from decoder,which could offer Max. current is 850mA for Load.If power
supply is AC24V, could get AC24V form decoder.
4.Covering the back-lid and tighten the screws. When using,please not to put the wiper to
work continuously for long times,otherwise ,It will effect the use time.
Ⅶ.Connection Figure
CN1 CN2
COM
IRIS
ZOOM
GND
FOCUS
+12V
CPU
CN6
BURS H
CN7
NOP
CN8
CN5
GND
CN3
CN3:communication port,receipting TTL level。
CN2:offering camera’s power supply (DC12V)
CN4:AC24V OUT could offer AC24V 。
CN6:low 0℃ , heater will startup.
FAN
AC24 V
AC24 V
IN
OUT
RXD
TXD
CN4
Figure 1
Tr ansf or mer
CN7:connecting heater。
CN8:over 45℃, fan will startup;
Command For Wiper Function:
CALL 58 – Wiper ON
PRESET 58 – Wiper OFF