1x2 HDMI Splitter/Repeater
over Cat.X with Local Out
User Manual
15-HS102TR
1
Safety and Notice
The 15-HS102TR 1x2 HDMI Splitter/Repeater over Cat.X with Local Out has been tested
for conformance to safety regulations and requirements, and has been certified for
international use. However, like all electronic equipments, the 15-HS102TR should be used
with care. Please read and follow the safety instructions to protect yourself from possible
injury and to minimize the risk of damage to the unit.
z Follow all instructions and warnings marked on this unit.
z Do not attempt to service this unit yourself, except where explained in this manual.
z Provide proper ventilation and air circulation and do not use near water.
z Keep objects that might damage the device and assure that the placement of this unit is
on a stable surface.
z Use only the power adapter and power cords and connection cables designed for this
unit.
z Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the
device before cleaning.
TABLE OF CONTENTS
z INTRODUCTION ..................................................................................................2
z FEATURES........................................................................................................... 2
z SPECIFICATIONS ................................................................................................3
z PANEL DESCRIPTIONS ....................................................................................4
z PACKAGE CONTENTS ......................................................................................4
z CONNECTION DIAGRAM .................................................................................... 5
z PIN DEFINITION...................................................................................................6
z NOTICE ................................................................................................................ 7
z WARRANTY .........................................................................................................8
2
INTRODUCTION
The
15-HS102TR 1x2 HDMI Splitter/Repeater over Cat.X with Local Out
allows you to
distribute one of the two HDMI/DVI video sources 2 separate HDTV displays including one
remotely cascade output via Cat-5/5e cost effective cable. This splitter offers the most flexible
solution by which the high definition video and high quality audio can be transmitted to different
local locations through HDMI cables and also to the next stage over a long distance without
degrading the quality. The cascade ability allows pure digital video and audio broadcast station
by station and therefore make extending HDMI compliant video and audio anywhere feasible.
FEATURES
z
State-of-the-art Silicon Image (founder of HDMI) chipset embedded for utmost compatibility
and reliability
z
Support HDMI Deep Color & 3D / DVI 1.0 compliant
z
HDCP 1.1 compliant
z
Regenerates the HDMI signal
z
Supports audio output
z
Extends up to 60m (200ft) (720p / 1080i) of input Cat.X cable
z
Extends up to 15m (50ft) of output HDMI cable
z
Extends up to 60m (200ft) (720p / 1080i) of output Cat.X cable
z
Extends up to 40m (130ft) (1080p) of output Cat5/6 cable
z
Minimizes the cable skew by adjustable 8-level equalization control
z
Pure unaltered uncompressed 7.1ch digital HDMI over Cat.X cable transmission
z
Allows cascading
z
Perfectly integrated with other HDMI over Cat.X series products
3
SPECIFCATIONS
Model Name 15-HS102TR
Technical
Role of usage 1x2 Distribution Amplifier Transmitter [TX]
HDMI compliance HDMI Deep Color & 3D
HDCP compliance Yes
Video bandwidth Single-link 225MHz [6.75Gbps]
Video support 480i / 480p / 720p / 1080i / 1080p60 up to 36-bit color
Transmission over UTP
cable (24-bit)
Full HD (1080p) – 40m (130ft) [Cat5e] / 50m (165ft) [Cat6]
HD (720p/1080i) – 50m (165ft) [Cat5e] / 60m (200ft) [Cat6]
Audio support Surround sound (up to 7.1ch) or stereo digital audio
Signal equalization 8-level digital output signal equalization
Input TMDS signal 1.2 Volts [peak-to-peak]
Input DDC signal 5 Volts [peak-to-peak, TTL]
ESD protection
[1] Human body model — ±19kV [air-gap discharge] &
±12kV [contact discharge] [2] Core chipset — ±8kV
PCB stack-up 4-layer board [impedance control — differential 100Ω; single 50Ω
Input 1x RJ-45
Output 1x HDMI + 1x RJ-45 + 1x 3.5mm audio socket
HDMI connector Type A [19-pin female]
RJ-45 connector WE/SS 8P8C with 2 LED indicators
3.5mm connector Earphone jack for stereo audio
DIP switch None
Rotary control switch HDMI Signal Level
Mechanical
Housing Metal enclosure
Dimensions
[L x W x H]
180 x 106 x 30 mm
Weight g 530 g
Fixedness Wall-mounting case
Power supply 5V 4A DC
Power consumption 7.5 Watts [max]
Operation temperature 0~40°C [32~104°F]
Storage temperature -20~60°C [-4~140°F]
Relative humidity 20~90% RH [no condensation]
4
PANEL DESCRIPTIONS
1. HDMI / DVI LED: Input signal format indicator [bright: HDMI signal, dim: DVI signal]
2. 16-level rotary control: Adjust the 16-level equalization control corresponding to the
transmission distance of receiving HDMI signals. For surround
sound audio output, please adjust from 0-to-7 (longest-to-shortest
transmission length). For stereo audio output, please adjust from
8-to-F (longest-to-shortest transmission length). It is recommended
to adjust from 7-to-0 or from F-to-8 to find the optimal visual
experience.
3. HDMI Signal IN: Link to 15-HS102T or 15-HS102TR with a Cat-5/5e/6 cable.
4. Audio OUT: Plug in a local speaker here.
5. HDMI OUT: Connect to a local HDMI display with a HDMI male-male cable here.
6. HDMI Signal OUT: Link to each HDMI display via a Cat-5/5e/6 cable with a HDMI over Cat.X
receiver 15-HE101R or 15-HE101PR; or link to another 15-HS102TR for
cascading.
7. +5V DC: Connect to 5V 4A DC power supply.
PACKAGE CONTENTS
15-HS102TR
x1
DC 5V 4A wall wart
x1
User Manual x1 Screws x4
Plastic-Conical-Anchor x4
5
CONNECTION DIAGRAM
6
PIN DEFINITION
HDMI
Type A (Receptacle) HDMI
Pin 1 TMDS Data2+ Pin 11 TMDS Clock Shield
Pin 2 TMDS Data2 Shield Pin 12 TMDS Clock–
Pin 3 TMDS Data2– Pin 13 NC
Pin 4 TMDS Data1+ Pin 14 Reserved (N.C. on device)
Pin 5 TMDS Data1 Shield Pin 15 SCL
Pin 6 TMDS Data1– Pin 16 SDA
Pin 7 TMDS Data0+ Pin 17 DDC/CEC Ground
Pin 8 TMDS Data0 Shield Pin 18 +5V Power
Pin 9 TMDS Data0– Pin 19 Hot Plug Detect
Pin 10 TMDS Clock+
RJ45 / Cat.X
7
NOTICE
1. If the DVI or HDMI device requires the EDID information, please use EDID Reader/Writer to
retrieve and provide DVI or HDMI display EDID information.
2. All HDMI over Cat.X transmission distances are measured using Belden 1583A CAT5e
125MHz UTP cable and ASTRODESIGN Video Signal Generator.
3. The transmission length is largely affected by the type of Cat-5/5e/6 cables, the type of HDMI
sources, and the type of HDMI display. The testing result shows solid UTP cables (usually in
the form of 330m bulk cables) can transmit a lot longer signals than stranded UTP cables
(usually in the form of fixed length patch cords). Shielded STP cables are better suited than
unshielded UTP cables. A solid UTP Cat-5e cable shows longer transmission range than
stranded STP Cat-6 cable. For long extension applications, solid UTP/STP cables are the
only viable choice.
4. EIA/TIA-568-B termination (T568B) for category cables is recommended.
5. To reduce the interference among the unshielded twisted pairs of wires in Cat-5/5e/6 cable,
one can use double shielded STP cables to improve EMI problems, which is worsen in long
transmission.
6. Because the quality of the CAT5/6 cables has the major effect on how long the transmission
limit can achieve and how good is the received picture quality, the actual transmission range
is subject to one's choice of Cat-5/5e/6 cables. For desired resolutions greater than 1080i or
1280x1024, a Cat-6 cable is recommended.
7. If your HDMI display has multiple HDMI inputs, it is found that the first HDMI input [HDMI
input 1] generally can produce better transmission performance among all HDMI inputs.
Performance Guide for HDMI over Category Cable Transmission
Performance rating Type of category cable
Wiring Shielding CAT5 CAT5e CAT6
Unshielded (UTP)
Solid
Shielded (STP)
Unshielded (UTP)
Stranded
Shielded (STP)
Termination
Please use EIA/TIA-568-B termination (T568B) at any
time
8
WARRANTY
The SELLER warrants the
15-HS102TR 1x2 HDMI Splitter/Repeater over Cat.X with
Local Out
free from defects in the material and workmanship for 1 year from the date of
purchase from the SELLER or an authorized dealer. Should this product fail to be in good
working order within 1 year warranty period, The SELLER, at its option, repair or replace the unit,
provided that the unit has not been subjected to accident, disaster, abuse or any unauthorized
modifications including static discharge and power surge. This warranty is offered by the
SELLER for its BUYER with direct transaction only. This warranty is void if the warranty seal on
the metal housing is broken.
Unit that fails under conditions other than those covered will be repaired at the current price
of parts and labor in effect at the time of repair. Such repairs are warranted for 90 days from the
day of reshipment to the BUYER. If the unit is delivered by mail, customers agree to insure the
unit or assume the risk of loss or damage in transit. Under no circumstances will a unit be
accepted without a return authorization number.
The warranty is in lieu of all other warranties expressed or implied, including without
limitations, any other implied warranty or fitness or merchantability for any particular purpose, all
of which are expressly disclaimed.
Proof of sale may be required in order to claim warranty. Customers outside Taiwan are
responsible for shipping charges to and from the SELLER. Cables and power adapters are
limited to a 30 day warranty and must be free from any markings, scratches, and neatly coiled.
The content of this manual has been carefully checked and is believed to be accurate.
However, The SELLER assumes no responsibility for any inaccuracies that may be contained in
this manual. The SELLER will NOT be liable for direct, indirect, incidental, special, or
consequential damages resulting from any defect or omission in this manual, even if advised of
the possibility of such damages. Also, the technical information contained herein regarding the
15-HS102TR
features and specifications is subject to change without further notice.
2012/11/5
Loading...