Coppernic HFELYWAP3 Users Manual

April 26, 2011

DPD 110052 A00 Sheet 1 of 6

MORPHOCHECK 2

EXPANSION MODULE INSTRUCTIONS

Important: All Approval and safety information is outlined in the ‘Workabout pro 3 Handheld-computer
User Manual’. This manual is available on our website www.psion.com through the Teknet extranet

Easily installable expansion modules for the WORKABOUT PRO 3 allow you to customise this hand-held
to meet your specific mobile computing requirements. This chapter outlines how to install the SAM.

Before installing SAM in the WORKABOUT PRO 3, all power sources must be turned off.

• Remove the batteries. If your unit is using AC power, disconnect it.

• Slide the switch to position OFF to shut off internal battery power.

With the power shut down, you can install the SAM.

MORPHOCHECK 2 2X0 MORPHOCHECK 2 300

2D Imager

Smart Card Reader

Finger Print
Reader

RFID Reader

OCR Reader

April 26, 2011

DPD 110052 A00 Sheet 2 of 6

MORPHOCHECK 2 200

• Unscrew the screws to remove the back plate.

MORPHOCHECK 2 250

• Unscrew the screws to remove the 2D Imager.

MORPHOCHECK 2 300

• Unscrew the screws to remove the OCR Reader.

WARNING TO THE GROUND AND
FLEX CONNECTIONS