Cooper Lighting ELVSTPP66344KZ, VSTPP66344KZ Installation Instructions

Instruction Leaflet

K1112V

November 2016

Instruction Manual - K1112V
November 2016

VersaPanel

VersaPanel

Product luminaires comply with BSEN60598 Class1/Class 2.

This luminaire has an ambient temperature range of 5C to 25C

1

Typical 600x600mm

Suspended Ceiling Grid

Ceiling Tile

Remove the ceiling tile from the
position the LED Panel is to be
installed

3

IP44

2

ENSURE MAINS SUPPLY IS SWITCHED OFF

Class I Product

Wire LED Driver to mains supply,

Live, Eath and Neutral

IMPORTANT NOTE:

accordance with local wiring

LUMINAIRE MUST BE EARTHED

Class II Product

Wire to Live & Neutral on LED driver

(Brown)

(Blue)

Position Driver on ceiling tile next to
LED Panel

4

ENSURE MAINS SUPPLY IS SWITCHED OFF

cables.

ermination to be in

T

Live (Brown)

Earth (Yellow/Green)

Neutral (Blue)

L
N

connect the

regulations

Safe Operation

1. Check the rating label for voltage and frequency before connecting this luminaire to the electrical supply.

2. Ensure that the mains supply is switched off when working on this luminaire, whether installing or carrying
out any other servicing.

3. To prevent damage to driver, do not mix with conventional magnetic ballasts on the same electrical circuit.

4. Where use in more onerous situations is required, e.g. In part-completed buildings before “drying-out” is
completed, or areas where ambient temperatures are outside the normal temperature range, then
consult our Sales Office.

Servicing and Disposal

1. At commissioning and handing over of installation ensure that a copy of these instructions is presented to
the authority responsible for the operation and maintenance of the luminaries.

2. Servicing, e.g. cleaning, must only be carried out after the electricity supply has been switched off. It
must not be assumed that luminaries with lamps not lit are switched off-always check before servicing.

3. Cleaning should be carried out at regular intervals to ensure that dirt does not accumulate to an extent
that will impair the thermal safety or optical performance of the luminaire. Regular cleaning will also
ensure that the optical performance of the luminaries is maintained.

4. Avoid touching the LED array surface. To clean - Blow surface with either dry air or nitrogen gas.

5. At the end of life the luminaire is classed as WEEE under directive 2002/96/EC and should be disposed
of in accordance with local legislation.

Luminaire Cleaning

End of Life and Components Disposal

Move LED Panel into aperature in
ceiling and position halfway.
Take note of the below points:

1. Before installation ensure that the ceiling support system
is adequate to carry total LED Panel weight.

2. Ensure prepared ceiling aperature will accommodate the
LED Panel dimensions for installation.

Connect the driver
to the LED Panel

1. Position LED Panel fully in aperature.

2. Ensure LED Panel rests fully on ceiling grid.

Eaton
Wheatley Hall Road, Doncaster, South Yorkshire, DN2 4NB

Sales

T: [phone]
F: [phone]
E: [e-mail]

General

[phone]
[phone]
[e-mail]

WEEE

International Sales

[phone]
[phone]
[e-mail]

K1112V