Cooper Lighting Lifeway II User Manual
SURE-LITES
SURE-LITES
SURE-LITESSURE-LITES
LIFEWAY II SERIES
LIFEWAY II SERIES
LIFEWAY II SERIESLIFEWAY II SERIES
MICRO MODULAR
MICRO MODULAR
MICRO MODULARMICRO MODULAR
INVERTER SERIES
INVERTER SERIES
INVERTER SERIESINVERTER SERIES
500W – 2,000W
Users Manual
C A U T I O N
READ ENTIRE MANUAL AND REVIEW ALL DOCUMENTATION BEFORE ATTEMPTING SYSTEM
INSTALLATION
FOR SERVICE OR INSTALLATION INFORMATION:
TELEPHONE: (610) 868-5400 (24 HR. HOTLINE)
FAX: (610) 954-8227
FOR YOUR PROTECTION
PLEASE COMPLETE AND RETURN WARRANTY REGISTRATION CARD IM MEDIATELY.
1
113904 – System Users Manual
This unit contains LETHAL VOLTAGES. All repairs and service should be performed by
AUTHORIZED SERVICE PERSONNEL ONLY! There are NO USER SERVICEABLE
PARTS inside this unit.
IMPORTANT SAFEGUARDS
When using electrical equipment, you should always follow basic safety
precautions, including the following:
1. READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
2. Do not install the system outdoors.
3. Do not install near gas or electric heaters or in other high-temperature
locations.
4. Use caution when servicing batteries. Depending on battery type, batteries
contain either acid or alkali and can cause burns to skin and eyes. If
battery fluid is spilled on skin or in the eyes, flush with fresh water and
contact a physician immediately.
5. Equipment should be mounted in locations where unauthorized personnel
will not readily subject it to tampering.
6. The use of accessory equipment not recommended by Manufacturer may
cause an unsafe condition and void the warranty.
7. Do not use this equipment for other than its intended use.
8. Qualified service personnel must perform all servicing of this equipment.
SAVE THESE INSTRUCTIONS
The installation and use of this product must comply with all national, federal,
state, municipal, or local codes that apply. If you need help, please call
Service.
2
113904 – System Users Manual
User’s Guide
An on-site permanent log of the inspection, testing, and maintenance of the emergency
electrical power supply system shall be maintained in accordance with the
Manufacturer's operating manual. The log shall include:
The date on which the inspection, testing, and maintenance exercise was carried out.
The name of the person(s) who performed the inspection, testing, and maintenance.
A note of any unsatisfactory condition observed or discovered, and the steps taken to
correct the condition.
3
113904 – System Users Manual
C H A P T E R 1
INTRODUCTION
Keep this manual and the System Installation Guide in the folder mounted inside the
unit.
This unit is a microprocessor controlled PWM (Pulse Width Modulated) pure sine wave
based DC to AC power inverter utilizing MOSFET technology. It integrates a fully automatic
3-rate battery charger, a solid-state transfer system, control circuitry, self testing and
recording digital meter display, and maintenance free sealed lead calcium type batteries.
The system components are carefully matched to make the unit a completely self-contained,
fully automatic standby power source for operation on all types of lighting loads. The
batteries are sized and tested per UL-924 and Life Safety Code ANSI / NFPA 101, providing
emergency power for a minimum of 90 minutes.
If the duration of a power failure is greater than the batteries storage capability, the inverter
will automatically shut down when the battery voltage reaches 85% of the nominal DC
voltage. This feature protects the battery from being permanently damaged from a deep
discharge that could cause cell reversal. This battery protection feature is called "Low
Voltage Disconnect" or L.V.D.
When the AC power is restored after a full discharge, the system will be ready for another
power failure within 24hrs. If another power failure occurs before the 24-hour recharge time,
the run time will be decreased.
The front panel display incorporates an alphanumeric 2x20 LCD character display, LED
status indicators and a 4 x 4 keypad. All user interface functions are available from the front
panel assembly.
Utilizing a small footprint, this unit is for use with any lighting load including quartz, HID,
incandescent, fluorescent and halogen.
HOW TO USE THIS MANUAL
This manual tells you how to start, operate, and communicate with your unit and lets you
know how to get more information for special situations.
Please record your unit’s model number, serial number, and part number below. You can
find these numbers on the labels on the inside panel.
Model Number __________________________
Serial Number __________________________
Part Number ___________________________
4
113904 – System Users Manual
Service and Support
We are committed to outstanding customer service. A service technician is
available 24 hours a day, 365 days a year. Service is also available 24 hours a day to give
you access to technical notes and product information. You can also visit our web site.
NOTE: Please have your unit’s Serial and Model numbers available when you call; this
number is located behind the left door.
Contact SERVICE one of the following ways:
Service Number: 610-868-5400
Service Fax: 610-954-8227
5
113904 – System Users Manual
Loading...