Cooper Lighting HS1R-C, Hs 1r User Manual

Instruction Manual
Directives
Instrucciones

ENGLISH

FRANÇAIS

HS1R, HS1R-C

Power Failure Emergency Light

De Secours en Cas de Panne de Courant

Luz de Emergencia Para Apagones

ESPAÑOL

HS1R, HS1R-C

Installation InstructionsHow it works

Congratulations on your purchase of a Cooper Lighting Emergency Power
Failure light! You will find this product to be an invaluable aid in the event of a
power outage. The emergency lights will automatically turn ON when the power
fails, preventing you from being stranded in the dark at a time when you need
light the most.

WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit

ENGLISH

breaker before installing or servicing.

Do not use outdoors. Do not let power supply cords touch hot surfaces. Do not
mount near gas or electric heaters. Use only as intended as a power failure
light. The use of accessory equipment not recommended by manufacturer may
cause an unsafe condition. Servicing of this equipment should be performed by
qualified personnel. The lamps come with 6V, .9A wedge base bulbs
already installed.

Installation

Step 1: Select a mounting location. Mount the fixture where power cord can

easily reach a standard 120 Volt AC outlet.
Unit must be plugged in to charge and to
recognize a power failure.

Step 2: Put two screws 5-1/4˝ apart into wall or

other mounting surface.

Step 3: Using the keyhole slots on the

backplate of the light, mount light
onto screws (Fig. 1).

Step 4: Adjust lamps towards an exit path or

as needed by loosening screws
in swivels and rotating heads.

Step 5: Plug unit into standard 120 Volt AC outlet.

Step 6: Select “1 Light” or “2 Lights” on the light selection switch, located on

the side of the unit (Fig. 1).

1 Light - One lamp only comes on when power fails.

2 Lights - Both lamps come on when power fails.

Note: The switch must be set to either “1 Light” or “2 Lights” when the unit is
plugged into an AC outlet to charge the battery. Please allow 48 hours to
completely charge the battery to its rated capacity.

St

ep 7:

est/ Charge” LED display will light up when the unit is

“T

The
being charged.

Operation

Step 1: During a power failure, either one or both lamps will come on,

depending on the position of the light selection s

Read and follow all safety instructions.

Light Selection

Switch

Wiring:

witch.

Key Hole

Slots

Fig. 1

all for customer service and/or missing or damaged parts (800-334-6871)

C

2

Operating Times (Fully Charged Battery)

1 Light - 4 hours
2 Light - 2 hours

Step 2: During normal power conditions (no power failure), unit will light

when unplugged.

Testing

Depress the “Test/Charge” LED at the lower right corner of the unit. One or both
lamps will illuminate depending on the position of the light selection switch.

One Year Limited Warranty

Cooper Lighting (“the Company”) warrants this product (“the product”) against
defects in material or workmanship for a period of one year from date of
original purchase, and agrees to repair or, at the Company’s option, replace a
defective product without charge for either replacement parts or labor during
such time. This does not include labor to remove or install fixtures.

This warranty is extended only to the original purchaser of the product.
A purchaser’s receipt or other proof of date of original purchase acceptable to
the Company is required before warranty performance shall be rendered.

This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb or failure of
the product caused by accident, misuse, abuse, lack of reasonable care,
alteration, or faulty installation, subjecting the product to any but the specified
electrical service or any other failure not resulting from defects in materials or
workmanship. Damage to the product caused by separately purchased,
non-Company brand replacement bulbs and corrosion or discoloration of brass
components are not covered by this warranty.

There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL
MPLIED WARRANTIES, IF ANY, INCLUDING IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY.

Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitations on how long an implied warranty
lasts, so the above exclusions or limitations may not apply to you.

No other warranty, written or verbal, is authorized by the Company.
This waranty gives you specific legal rights, and you may also have other
rights which vary from state to state.

To obtain warranty service, please write to Cooper Lighting 1121 Highway 74
South, Peachtree City, GA 30269. Enclose product model number and

oblems you are experiencing, along with your address and telephone number.

pr

ENGLISH

Call for customer service and/or missing or damaged parts (800-334-6871)

3